Tefal GC730D34 Optigrill+ SMART - Инструкция по эксплуатации - Страница 14

14

EN

Troubleshooting guide

Problem

Cause

Solution

Button   

flashing

+ 

 Indicator light 

solid green

+ 

Button   

blinking

•  S w i t c h i n g   o n   t h e 

appliance or star ting 

an automatic cooking 

c y c l e   w i t h   f o o d 

a n d  w i t h o u t  p l a t e s 

p re h e a t i n g  (m a n u a l 

mode is automatically 

activated).

•  2 possible options: 

–  ( M a n u a l   m o d e)   C h o o s e   t h e 

temperature setting by pressing the 

 button and then press 

OK

. Allow 

to cook, but you must monitor the 

cooking.

–  (Automatic cooking program) Stop 

the appliance, remove the food, close 

the appliance properly, re-program 

the appliance and wait until end of 

preheating.

The appliance stops during the preheating 

or cooking cycle.

•  The appliance has been 

kept open for too long 

while cooking. 

•  The appliance has been 

idle too long after the 

end of warm up or keep 

warm. 

•  Disconnec t the appliance from the 

outlet and leave for 2-3 mins., restart 

the process. The next time you use the 

appliance, make sure you open and close 

it quickly for best cooking results. If the 

problem occurs again contact your local 

Tefal customer service. 

The indicator light 

will flash white

+

 Button 

/

/

/

/

flashing

+

  Intermittent beeping

•  Appliance failure.

•  Appliance stored or used 

in a room that is too cold.

•  D i s c o n n e c t   a n d   r e c o n n e c t   y o u r 

appliance and immediately restart a 

preheat cycle. If the problem persists, 

contact Customer Service.

The device does not beep.

The indicator light 

will flash white

+

 Button   

flashing

+

  Continuous beeping

•  Appliance failure.

•  Unplug the appliance and contac t 

customer service.

After preheating, I placed the food inside 

and closed the appliance, 

 but the 

indicator light stays pink and cooking does 

not begin.

•  The quantity of food 

inside the appliance is 

greater than 4 cm.

•  Th thickness of the food should not 

exceed 4 cm.

•  The grill was not opened 

completely when placing 

the food inside.

•  Open the grill completely and close it 

again.

•  The appliance does not 

detect food inside 

The 

food thickness is too 

thin, “OK” is flashing.

•  For thinner foods, press the   button 

to ensure the appliance recognises the 

food and that the cooking cycle begins.

The appliance turns itself to manual mode

+

 The indicator light 

will flash red.

+

  button 

 temp control and   light 

fixed

•  Preheating time was cut 

short.

•  M o nito r  t h e  co o k in g  p e r io dic a l ly 

(for use in manual mode).

 Or

•  Press the ON/OFF button to stop the 

grill, remove food, close the grill, select 

the new cooking program you wish to 

use and wait for the preheating cycle to 

finish before adding the food (for use in 

automatic mode).