Husqvarna LC 140P 9704881-01 - Инструкция по эксплуатации - Страница 11

3. Loosen the lower knobs.
4. Move the knobs to the lower end of the grooves on

the left and the right side of the product. (Fig. 24)

5. Fold the handle forward. (Fig. 25)

To set the product in operation position

1. Lift the handlebar until the lower handle locks in

operation position. (Fig. 26)

2. Move the knobs up in the direction of the handle until

they stop and you hear a click.

3. Tighten the knobs fully. (Fig. 27)
4. Lift the top part of the handlebar.

5. Tighten the knobs fully. (Fig. 28)

To assemble the grass catcher

1. Put the top part of the grass catcher onto the lower

part of the grass catcher. (Fig. 29)

2. Attach the grass catcher frame with the clips. (Fig.

30)

3. Lift the rear cover.
4. Attach the hooks on the grass catcher to the top

edge of the chassis. (Fig. 31)

5. Put the lower part of the grass catcher into the grass

discharge channel.

Operation

Introduction

WARNING: Before you operate the product,

you must read and understand the safety

chapter.

Husqvarna Connect

Husqvarna Connect is a free app for your mobile device.

The Husqvarna Connect app gives extended functions

for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and

servicing.

To start to use Husqvarna Connect

1. Download the Husqvarna Connect app on your

mobile device.

2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect

app to connect and register the product.

Before you operate the product

1. Read the operator's manual carefully and make sure

that you understand the instructions.

2. Examine the cutting equipment to make sure that it

is correctly attached and adjusted. See 

To examine

the cutting equipment on page 13.

3. Fill the fuel tank. See 

To fill fuel on page 11.

4. Fill the oil tank and do a check of the oil level. See 

To do a check of the oil level on page 14.

To fill fuel

If available, use gasoline with a low emission grade/

alkylate fuel. If gasoline with a low emission grade/

alkylate fuel is not available, use good quality unleaded

gasoline or leaded gasoline with octane number not less

than 91.

CAUTION: Do not use gasoline with an

octane number less than 91 RON. This can

cause damage to the product.

CAUTION: Replace the fuel filter yearly or

more frequently if it is necessary. A new fuel

filter is available at your Husqvarna dealer.

CAUTION: Always stop the engine before

you fill fuel.

CAUTION: Do not use pressurized starting

fluids.

1. Open the fuel tank cap slowly to release the

pressure.

2. Fill slowly with a fuel can. If you spill fuel, remove it

with a cloth and let remaining fuel dry off. (Fig. 32)

3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is

not tightened, there is a risk of fire.

5. Move the product a minimum of 3 m / 10 ft from the

position where you filled the tank before a start.

To set the cutting height

1. Move the cutting height lever rearward to increase

the cutting height.

2. Move the cutting height lever forward to decrease

the cutting height. (Fig. 33)

CAUTION: Do not set the cutting height too

low. The blades can hit the ground if the

surface of the lawn is not level.

1562 - 001 - 21.10.2020

11