Husqvarna LB 248S 9676563-01 - Инструкция по эксплуатации - Страница 11

Electrical start (LB 348SI)

1. Make sure that the battery is activated and charged.

See 

To start the battery on page 13.

2. Attach the battery to the engine.(Fig. 28 )
3. Push the start inhibitor out to the right (A).
4. Pull the start bar (B) against the handlebar to start

the starter motor. The starter motor stops when the

engine starts.(Fig. 29 )

To use the drive on the wheels

• Pull the drive bail in the direction of the handlebar.

(Fig. 30 )

• Before you pull the product rearward, disengage the

drive and push the product forward approximately

10 cm.

• Release the drive bail to disengage the drive, for

example when you go near an obstacle.

To stop the product

• To stop the drive only, release the drive bail.

• To stop the engine, release the engine brake handle.

To remove the battery

To prevent accidental start of the engine, remove the

battery on model LB 348SI when the product is not in

operation.
1. Press the lock buttons (A) and pull the battery out.

(Fig. 31 )

To get a good result

• Always use a sharp blade. A blunt blade gives an

irregular result and the cut surface of the grass

becomes yellow. A sharp blade also uses less

energy than a blunt blade.

• Do not cut more than ⅓ of the length of the grass.

Cut first with the cutting height set high. Examine the

result and lower the cutting height to an applicable

level. If the grass is very long, drive slowly and cut 2

times if necessary.

• Cut in different directions each time to prevent

stripes in the lawn.

Maintenance

Introduction

WARNING: Before you do maintenance, you

must read and understand the safety

chapter.

For all servicing and repair work on the product, special

training is necessary. We guarantee the availability of

professional repairs and servicing. If your dealer is not a

service agent, speak to them for information about the

nearest service agent.

Maintenance schedule

WARNING: For model LB 348SI, always

remove the battery before you do

maintenance, repairs or clean the product.

The maintenance intervals are calculated from daily use

of the product. The intervals change if the product is not

used daily.
For maintenance marked with * see instructions in 

Safety devices on the product on page 8.

Maintenance

Daily

Weekly

Monthly

Do a general inspection

X

Examine the oil level

X

Clean the product

X

Examine the cutting equipment

X

Examine the cutting cover and protective cover*

X

Examine the engine brake handle*

X

Examine the battery*

X

Examine the muffler*

X

Examine the spark plug

X

Change the oil (the first time after 5 h use, then after each 50 h use)

X

Change the air filter (after 50 h use)

X

135 - 004 - 21.11.2017

11