Husqvarna LB 248S 9676563-01 - Инструкция по эксплуатации - Страница 10

Assembly

Introduction

WARNING: Before you assemble the

product, read the safety chapter. On

LB 348SI, also remove the battery.

To assemble the handle

1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on

the left and the right side of the product.(Fig. 21 )

3. Set the handle height in one of the 2 available

positions.

4. Move the knobs up in the direction of the handle until

they stop and you hear a click.(Fig. 22 )

5. Tighten the knobs fully.

To set the product in transport position

1. Remove the battery (LB 348SI).
2. Loosen the lower knobs.
3. Move the knobs to the lower end of the grooves on

the left and the right side of the product.(Fig. 23 )

4. Fold the handle forward.(Fig. 24 )

To set the product in operation position

1. Fold the handle to upright position.(Fig. 25 )
2. Move the knobs up in the direction of the handle until

they stop and you hear a click.(Fig. 26 )

3. Tighten the knobs fully.
4. Attach the battery to the engine (LB 348SI).

Operation

Introduction

WARNING: Before you operate the product,

you must read and understand the safety

chapter.

Before you operate the product

1. Read the operator's manual carefully and make sure

that you understand the instructions.

2. Examine the cutting equipment to make sure that it

is correctly attached and adjusted. See 

To examine

the cutting equipment on page 12.

3. Fill the fuel tank. See 

To fill fuel on page 10.

4. Fill the oil tank and do a check of the oil level. See 

To do a check of the oil level on page 12.

To fill fuel

If available, use low-emission/alkylate gasoline. If low-

emission/alkylate gasoline is not available, use good

quality unleaded gasoline or leaded gasoline with octane

number not less than 90.

CAUTION: Do not use gasoline with an

octane number less than 90 RON (87 AKI).

This can cause damage to the product.

1. Open the fuel tank cap slowly to release the

pressure.

2. Fill slowly with a fuel can. If you spill fuel, remove it

with a cloth and let remaining fuel dry off.

3. Clean the area around the fuel tank cap.

4. Tighten the fuel tank cap fully. If the fuel tank cap is

not tightened, there is a risk of fire.

5. Move the product a minimum of 3 m (10 ft) from the

position where you filled the tank before a start.

To set the cutting height

The cutting height can be adjusted in five levels.
1. Move the cutting height lever rearward to increase

the cutting height.

2. Move the cutting height lever forward to decrease

the cutting height.

CAUTION: Do not set the cutting height too

low. The blades can hit the ground if the

surface of the lawn is not level.

To start the product

• Make sure that the ignition cable is connected to the

spark plug.

Manual start (LB 248S, LB 253S)

1. Stay behind the product.
2. Hold the engine brake handle against the handlebar.

(Fig. 27 )

3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope until you feel some

resistance.

5. Pull with force to start the engine.

WARNING: Do not twist the starter rope

around your hand.

10

135 - 004 - 21.11.2017