DEFORT DLM-2600-G 98291766 - Инструкция по эксплуатации - Страница 14

14

GB

STORAGE INSTRUCTIONS
(OFF SEASON)

The following steps should be taken to prepare lawn
mower for storage.
1. Following the 

fi

 nal cut of the season allow the fuel 

tank to run dry.
2. Clean and lubricate mower thoroughly as described 
in the lubrication instructions.
3. Refer to engine manual for correct engine storage 
instructions.
4. Lightly coat mower’s cutting blade with chassis 
grease to prevent rusting.
5. Store mower in a dry, clean area.

NOTE:
- When storing any type of power equipment 
in an unventilated or material storage shed;

- Care should be taken to rust-proof the equipment.
Using a light oil or silicone, coat the equipment, 
especially cables and all moving parts.
- Be careful not to bend or kink cables.
- If the starter rope becomes disconnected from rope 
guide on handle, disconnect and ground the spark 
plug wire, Depress the blade control handle and pull 
the starter rope out from engine slowly. Slip the starter 
rope into the rope guide bolt on handle.

ENGINE AIR CLEANER

CAUTION: Do not allow dirt or dust to clog 
the air 

fi

 lter foam element.

The engine air cleaner element must be 

serviced (cleaned) after 25 hours normal mowing. The 
foam element must be serviced regularly if the mower 
is used in dry dusty conditions.

TO CLEAN AIR FILTER

1. Remove screw.
2. Remove cover.
3. Wash 

fi

 lter element in soap water. DO NOT USE

GASOLINE!
4. Air  dry 

fi

 lter element.

5. Place a few drops of SAE30 oil on the foam 

fi

 lter and 

squeeze tightly to remove any excess oil.
6. Reinstall 

fi

 lter.

NOTE: Replace 

fi

 lter if frayed, torn, damaged 

or unable to be cleaned.

CUTTING BLADE

CAUTION: Be sure to disconnect and ground 
the spark plug wire before working on the 
cutting blade to prevent accidental engine 

starting. Protect hands by using heavy gloves or a rag 
to grasp the cutting blades.

WARNING: Periodically inspect the blade 
adapter for cracks, especially if you strike a 
foreign object. Replace when necessary. For 

best results your blade should be sharp. The blade 
may be resharpened by removing it and either grinding 
or 

fi

 ling the cutting edge keeping as close to the original 

bevel as possible. It is extremely important that each 
cutting edge receives an equal amount of grinding to 
prevent an unbalanced blade. Improper blade balance 
will result in excessive vibration causing eventual 
damage to the engine and mower.

BLADE MOUNTING TORQUE

Center Bolt must be tightened to 35 - 45 Nm torque. To 
insure safe operation of your unit. ALL nuts and bolts 
must be checked periodically for correct tightness. After 
prolonged use, especially in sandy soil conditions, the 
blade will become worn and lose some of the original 
shape. Cutting ef

fi

 ciently will be reduced and the blade 

should be replaced. Replace with an approved factory 
replacement blade only. Possible damage resulting 
from blade unbalance condition is not the responsibility 
of the manufacturer.