AL-KO 4705 E - Инструкция по эксплуатации - Страница 19

Assembly

469494_b

19

Do not start the motor if you are standing in

front of the discharge chute.
Start or operate the starter switch with caution

according to the manufacturer instructions.
Observe  the  local  regulations  governing  the

minimum age of the operator.
Do not operate the device when under the in-

fluence of alcohol, drugs or medication.
Prior to each use, check the unit for damage

and have damaged or worn parts replaced.
Remove foreign objects in the working area.
Keep  connecting  cables  out  of  the  working

area.
Wear suitable work clothing:

Long trousers
Firm and slip-resistant footwear

Ensure  that  you  have  a  sound  footing  when

working.
Keep  other  persons  away  from  dangerous

areas.
Keep  body,  body  parts  and  clothing  away

from the cutter area.
Only work when there is adequate daylight or

artificial lighting.
Always  disconnect  the  plug  from  the  mains

and wait for the unit to come to a standstill:

Whenever you leave the lawn mower
Before  you  inspect  the  lawn  mower,

clean it or perform work on it
After faults or unusual vibrations occur in

the unit
Before loosening blockages
Before eliminating stoppages
After contact with foreign bodies

ADVICE

After contact with foreign objects inspect

the mower for damage. Perform the ne-

cessary repairs before starting again and

begin working with the lawn mower.

If  the  lawn  mower  begins  to  vibrate  strongly

in an unusual way, and immediate inspection

is necessary:

Inspect for any damage
Perform  the  necessary  repair  of  dama-

ged parts
Tighten all nuts, bolts, and screws firmly

Play special attention when turning the lawn

mower or pulling it towards you.
Do  not  mow  over  obstacles  (e.g.  branches,

roots of trees).
Only remove cuttings when the motor is at a

standstill.
Never lift or carry the unit while the motor is

running.
Never leave the device unattended when it is

ready for operation.

ADVICE

If  the  mains  supply  conditions  are  not

sufficient,  brief  drops  in  the  mains  vol-

tage may occur when the unit is switched

on and this may affect other devices (e.g.

flickering lamps).
For a mains impedance of Zmax < 0.286

Ω these types of interference are not to

be expected.

ASSEMBLY

Observe the enclosed installation instructions.

CAUTION!

The  unit  must  only  be  operated  after  it

has been fully assembled

OPERATION

Adjust the cutting height.

CAUTION!
Risk of injury!

Adjust the cutting height only when motor

is switched off and the cutting blade has

stopped!

ADVICE

Always adjust all wheels to the same cut-

ting height.
Cutting  height  adjustment  depends  on

the model.

Axle adjustment or central adjustment

ADVICE

Always  adjust  both  axles  to  the  same

cutting height.

1. To  unlock,  press  the  lever  to  the  side  and

hold. (1)