Makita M3602 - Инструкция по эксплуатации - Страница 8

8 ENGLISH

ENGLISH (Original instructions)

SPECIFICATIONS

Model:

M3602

Collet chuck capacity

12 mm or 1/2″

Plunge capacity

0 - 60 mm

No load speed

22,000 min

-1

Overall height

300 mm

Net weight

5.7 kg

Safety class

/II

• 

Due to our continuing program of research and development, the specifications herein are subject to change without notice.

• 

Specifications may differ from country to country.

• 

Weight according to EPTA-Procedure 01/2014

Intended use

The tool is intended for flush trimming and profiling of 

wood, plastic and similar materials.

Power supply

The tool should be connected only to a power supply of 

the same voltage as indicated on the nameplate, and 

can only be operated on single-phase AC supply. They 

are double-insulated and can, therefore, also be used 

from sockets without earth wire.

Noise

The typical A-weighted noise level determined accord-

ing to EN62841-2-17:

Sound pressure level (L

pA

) : 84 dB(A)

Sound power level (L

WA

) : 95 dB (A)

Uncertainty (K) : 3 dB(A)

NOTE:

 The declared noise emission value(s) has 

been measured in accordance with a standard test 

method and may be used for comparing one tool with 

another.

NOTE:

 The declared noise emission value(s) 

may also be used in a preliminary assessment of 

exposure.

WARNING:

Wear ear protection.

WARNING:

The noise emission during actual 

use of the power tool can differ from the declared 

value(s) depending on the ways in which the 

tool is used especially what kind of workpiece is 

processed.

WARNING:

Be sure to identify safety mea

-

sures to protect the operator that are based on an 

estimation of exposure in the actual conditions of 

use (taking account of all parts of the operating 

cycle such as the times when the tool is switched 

off and when it is running idle in addition to the 

trigger time).

Vibration

The vibration total value (tri-axial vector sum) deter

-

mined according to EN62841-2-17:

Work mode: cutting grooves in MDF

Vibration emission (a

h

) : 3.1 m/s

2

Uncertainty (K) : 1.5 m/s

2

NOTE:

 The declared vibration total value(s) has been 

measured in accordance with a standard test method 

and may be used for comparing one tool with another.

NOTE:

 The declared vibration total value(s) may also 

be used in a preliminary assessment of exposure.

WARNING:

The vibration emission during actual 

use of the power tool can differ from the declared val

-

ue(s) depending on the ways in which the tool is used 

especially what kind of workpiece is processed.

WARNING:

Be sure to identify safety measures 

to protect the operator that are based on an estima

-

tion of exposure in the actual conditions of use (tak

-

ing account of all parts of the operating cycle such 

as the times when the tool is switched off and when 

it is running idle in addition to the trigger time).

EC Declaration of Conformity

For European countries only

The EC declaration of conformity is included as Annex A 

to this instruction manual.

General power tool safety warnings

WARNING:

Read all safety warnings, instruc-

tions, illustrations and specifications provided with this 

power tool.

 Failure to follow all instructions listed below 

may result in electric shock, fire and/or serious injury.

Save all warnings and instruc-

tions for future reference.

The term "power tool" in the warnings refers to your 

mains-operated (corded) power tool or battery-operated 

(cordless) power tool.