Ecosoft FK1235CABCEMIXC - Инструкция по эксплуатации - Страница 29

29

INSTRUCTION MANUAL ECOSOFT

®

 MEDIA SYSTEMS

5. MAINTENANCE

Brine tank must always contain enough salt pellets. Salt level must always be above the 
water surface. Do not use any type of salt other than salt pellets for softener regeneration. 

To avoid  fouling  of media  during  prolonged  downtime  without  power and  water supply, fill 

the FRP tank with brine as follows. Start manual regeneration, wait 20 minutes into the 

brine  stage,  then  shut  off  water  supply  and  scroll  through  the  rest  of  regeneration  cycles 
by pressing REGEN until the control valve flashes SOFTENING and then displays current 
time. Then, turn off the power of control valve. Also, perform regeneration when resuming 

service after prolonged downtime.

Check the equipment for any damage and inspect pipework for leaks every few weeks. 

Correct  the  control  valve’s  time  if  it  is  off.  Replace  sediment  pre-filter  if  pressure  drop 

exceeds 1 bar (14 psi).

6. PRECAUTIONS

Turn off power and water supply and relieve pressure before doing any maintenance.

Do not subject the system to vibration, shock, or mechanical load.

Electrical board of the control valve must be protected from water/moisture during regular 
service and any maintenance.

Hardness metals, iron, sediment and other impurities may form deposits on the surfaces of 

the control valve, which can lead to failure. It is advised to carry out preventive maintenance 

at least two times a years if there is an elevated concentration of iron in the influent water, 

or at least once a year otherwise.

Only store indoors, vertically. Ambient conditions must meet the requirements listed for 

installation room conditions in the Specifications section.

7. STORAGE