Ecosoft FK1235CABCEMIXC - Инструкция по эксплуатации - Страница 18

INSTRUCTION MANUAL ECOSOFT

®

 MEDIA SYSTEMS

18

2

.  Put plugs or caps on the top ends of the riser pipes to prevent getting any media inside 

the pipes. Pour the resin in both tanks using the funnel. When loading each tank, keep riser 

pipe vertical. If the pipe tilts, restore it to straight vertical direction. When finished, rinse the 

threads of tank openings with water to remove any beads of media stuck in the grooves.

3

.  Lock top distributor in circular slot at the bottom of the control valve’s shank. Install 

control valve on the lead tank. Mate the distributor with top end of riser pipe, then screw the 

control valve on. Install the second control valve on the second filter tank in the same way.

4

.  Connect drain pipe to the male threaded drain outlet of each control valve. Run the 

drain pipes to floor drain or gravity drain pipe socket. Secure the drain pipe end above the 
receiving fixture with at least 1″ air gap.

5

.  Place the brine tanks beside the FRP tanks. Install flexible tube in each control valve’s 

brine inlet and run it to its respective brine tank. Remove tank lid and brine well cap, pull the 
end of the tube inside and connect it to the brine valve, then re-assemble in reverse order. 
Fill the brine tanks with salt pellets at least half full.

6

.  Install  the  No  Hard  Water  Bypass  Valves  (NHWBPs)  on  both  control  valves’  Out  port 

using WS1 Vertical Adapters. Connect the Out ports to NHWBPs’ A ports. Then connect B 
ports of the NHWBPs to the downstream pipework.

Connect the control valves’ In ports to the water supply line without turning on the water 

supply. Use pipe thread elbow adapters for connecting the control valves and the NHWBP’s 

to the main pipework.

Do not confuse In and Out ports. They are embossed with direction arrows. Do not put any 

mechanical load on fittings or use them to support pipes.

7

.  Remove the front panel of each control valve by pulling the locking tabs on the left and 

right side. Run the power cord through the cord guide in each control valve’s backplate and 
connect it to the 12 VAC socket on the circuit board.

Connect the NHWBP cord to control valve board’s MAV socket. Install the microswitches in 

each control valve as shown in picture.

Route the microswitch wire through guide in the backplate and connect to the microswitch. 
Route the other end of the wire through the guide in the other control valve and connect to 
DP Switch socket. Repeat for the other valve.