Segway-Ninebot A6 - Инструкция по эксплуатации - Страница 5

07

08

WARNING 

Always wear a helmet and other protective gear to minimize any possible injury in the learning 
process. To reduce the risk of injury, adult supervision is required.

WARNING

Please check to make sure the kickscooter is powered off before assembly.

Note:

The screw should be placed behind. 

Note:

For your safety, the hub motor will 
not start if the speed is less than 
1.2 mph (2 km/h).

In the power-on state, when the 
kickscooter is still, you can step on 
the rear fender twice to switch the 
speed mode.

Please scan the QR code to learn how to activate the vehicle before riding, otherwise the vehicle 
speed will be limited to 3.1 mph (5km/h).

1

6+ years

≤88 lbs (40 kg)

3'5''–4'7'' (105–140 cm)

Activation

Switch Speed Mode

3. Assembly and Activation

Insert the stem to the bottom and adjust 
the handlebar direction to be perpendicular 
to the front wheel.

1

Start up: Place a single foot on the footboard to start the kickscooter, then you will hear one 
beep as the prompt.

2

Cruise: Hold the handlebar firmly with both hands and kick to start up. During the cruising, 
place both feet on the footboard and keep your balance.

4. Learn to Ride

2

Tighten the two screws on the clamp to 
make sure it is securely installed.

* When the indicator light turns red, please charge immediately.

NOTE:
The logo at the 
wheel faces 
forward.