Greenworks GD60CS40K2 60 В, с АКБ 2 А*ч и ЗУ 2006907UA - Инструкция по эксплуатации - Страница 4

WARNING

• If the battery pack or charger is damaged, replace

the battery pack or the charger.

• Stop the machine and wait until the motor stops

before you install or remove the battery pack.

• Read, know, and do the instructions in the battery

and charger manual.

1. Align the lift ribs on the battery pack with the

grooves in the battery compartment.

2. Push the battery pack into the battery compartment

until the battery pack locks into place.

3. When you hear a click, the battery pack is installed.

3.4

REMOVE THE BATTERY PACK

Figure 2
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.

4

OPERATION

NOTE

Remove the battery pack and keep hands clear of the

lock out button when you move the machine.

IMPORTANT

Examine the chain tension before each use.

4.1

EXAMINE THE CHAIN

LUBRICATION

NOTE

Do not use the machine without sufficient chain

lubrication.

Figure 1
1. Examine the lubricant level of the machine from the

oil indicator.

2. Add the lubricant if it is necessary.

4.2

HOLD THE MACHINE

Figure 8
1. Hold the chainsaw with your right hand at the rear

handle and left hand at the front handle.

2. Hold the handles with the thumbs and the fingers

around them.

3. Make sure that your left hand holds the front handle

and your thumb is below the handle.

4.3

START THE MACHINE

Figure 1.

1. Press the lock-out button.
2. Press the trigger while you hold the lock-out button.
3. Release the lock-out button.

IMPORTANT

The chain brake must be disengaged for the chain

saw to start. Activate the brake by moving the front

hand guard forwards.

4.4

STOP THE MACHINE

Figure 1.
1. Release the trigger to stop the machine.

4.5

OPERATE THE CHAIN BRAKE

WARNING

Make sure that your hands are on the handles at all

times.

Figure 22
1. Start the machine.
2. Turn your left hand around the front handle to

engage the chain brake.

3. Pull the handle guard / chain brake toward the front

handle to disengage the chain brake.

4. Call approved service center for repair before use if

• The chain brake does not stop the chain

immediately.

• The chain brake does not stay in the disengaged

position without aid.

4.6

FELL A TREE

Figure 9-10.
Recommendation that the first-time user should, as a

minimum practice, cutting logs on a saw-horse or

cradle.
Before you start to fell a tree, make sure that
• The minimum distance between the areas of

bucking and felling is two times the height of the

tree.

• The operation does not

• Cause injury to personnel.
• Hit utility lines. If the tree touches utility lines,

immediately tell the utility company.

• Cause losses in property.

• The user is not in the dangerous area, for example,

the downhill side of the area.

• The escape paths that extend back and diagonally

behind the felling direction are clear. The felling

direction is controlled by
• The natural lean of the tree.

6

English

EN