Philips RQ1090 - Инструкция по эксплуатации - Страница 9

Blocked shaving heads 

If the shaving heads are blocked, the shaving unit symbol and the tap 

symbol with exclamation mark flash. In this case, the motor cannot 

run because the shaving heads are soiled or damaged.  (Fig. 19)

Note: The displays of types RQ1062, RQ1060, RQ1052 and RQ1050 look 

different but show the same indication. 

When this happens, you have to clean the shaving unit or replace it. 

The shaving unit symbol and the tap symbol with exclamation mark 

continue to flash until you unblock the shaving heads.

Charging

Charging takes approx. 1 hour.

A fully charged shaver has a shaving time of up to 65 minutes, which is 

enough for approx. 21 shaves.

The actual shaving time is calculated by the shaver. If you have a heavy 

beard, the shaving time may be less than 65 minutes. The shaving time 

may also var y over time, depending on your shaving behaviour and beard 

type.

Quick charge

After the shaver has charged for 5 minutes, it contains enough energy for 

one shave.

 Put the small plug in the Power Pod (Fig. 0).

 Put the adapter in the wall socket. 

 Pull at the top of the lid () and remove it () (Fig. ).

  4 

 First insert the top of the shaver into the Power Pod () and then 

press the bottom part into the Power Pod () (Fig. ).

Note: The shaver cannot be placed in the Power Pod when the protection cap 

is on the shaving unit.

The display shows that the shaver is charging (see chapter ‘The 

display’).

-

-

-

,

English