Braun 8990 - Инструкция по эксплуатации - Страница 8

8

Quick cleaning

Press the foil release buttons (12) to lift the shaver foil 
(do not remove the foil completely). Switch on the shaver 
for approx. 5–10 seconds so that the shaved stubbles can 
fall out.

Thorough manual cleaning

Manual cleaning is recommended only when the 
Clean&Renew™ station is not available, e.g. when travel-
ling. 
Never use water to clean the shaver. 
Remove the shaver foil and tap it out on a flat surface. 
Using the brush, clean the inner area of the pivoting head. 
However, do not clean the shaver foil nor the cutter block 
with the brush as this may damage them.
If you do not use the Clean&Renew™ station for a longer 
period of time, you should apply a drop of light machine 
oil onto the shaver foil. 

Cleaning the housing

Clean the housing of shaver and station from time to time 
with a damp cloth, especially inside the opening of the 
station where the shaver rests.

Replacing the cartridge

After having pressed the lift button (4) to open the 
housing, wait for a few seconds before removing the used 
cartridge. 
Before discarding the used cartridge, make sure to close 
the openings using the lid of the new cartridge, since the 
used cartridge will contain contaminated cleaning 
solution. 

The shaver indicator lights

Pilot light (20): the shaver is connected to the mains. 

     
The red low-charge light (17) flashes when the battery 
capacity has dropped below 20%, provided the shaver is 
switched on. The remaining capacity will then be sufficient 
for 2 to 3 shaves.

fix

on

of

f

on

of

f

old

new

8990

0..20

40

60

      r

eset

foil r

ep

l

0...20

40

60

80

100

foil r

eplace+cut

t

foil r

eplace

+c

u

tt

empty

charge