Braun 1508 - Инструкция по эксплуатации - Страница 5

6

Cleaning and maintenance
After every shave, remove the foil 
frame 

7

(d) and tap out lightly. Brush 

out the cutter block 

6

with the clean-

ing brush 

9

(e). Do not clean the 

shaving foil with the cleaning brush 

9

to avoid damaging it. Approximately 
every four weeks clean the space 
between the longhair trimmer 

5

 and 

the shaver with the cleaning brush 

9

.

Clean the cutter block 

6

with Braun 

cleaning spray to maintain your shav-
er’ s top shaving performance and to 
keep it hygienic. After every cleaning 
replace the foil protection cap 

8

on 

the foil frame 

7

.

Changing the shaving parts
The shaving foil frame 

7

should be 

held at the two grooved surfaces and 
pulled off (d).

The cutter block 

6

can be removed 

(e.g. for cleaning) by turning it at 
right angles to the shaver and lifting 
it off (f). To replace the cutter block, 
snap it onto the holding studs (g). 
Replace the new foil frame in the 
right direction (d) until it locks in place.

Important
Buy only original Braun spare parts, 
especially when replacing the mains 
lead or the shaving foil frame 

7

. 

When buying a new shaving foil 
frame look for the 

 brand and 

the correct identification number 
«596» (h).

When looking to purchase a new 
Braun foil frame, ensure that you 
buy the right colour: a grey or black 
coloured frame.
Only this way you can be assured of 
a safe, close and efficient shave.

Parts for car or boat
When recharging your shaver in a car 
or boat use only the special Braun 
charging cord (No. 5- 001- 687) that is 
stated on the packaging for this 
purpose (available at your dealer or 
from a Braun Service Centre). Avoid 
direct sunlight on the shaver (see 
temperature range).

Subject to change without notice.

This product conforms to the 
EMC- Requirements as laid 
down by the Council Directive 
89/ 336/ EEC.