Braun 1508 - Инструкция по эксплуатации - Страница 4

5

The shaver automatically adapts to 
all international direct and alternating 
current voltages (12 – 240 V   /  50 or 
60 Hz) and all frequencies. The shaver 
can also be recharged on voltages 
below international standards in cars 
and boats, etc. However, a minimum 
12 V outlet (direct or alternating 
current) is required. Recharging this 
way takes approximately 20 hours, 
and requires a special charging cord.

The surrounding temperature should 
not be higher than + 25 °C when 
recharging at 12 V, to ensure the 
proper functioning of the shaver.

A full charge will give you approxi-
mately 35 minutes of cordless shav-
ing.

Preserving the cell unit
In order to preserve the life of the 
cell unit, it should be fully discharged 
approximately once every 6 months 
by normal shaving and then fully 
recharged from the mains until the 
charging pilot light 

1

goes off.

This procedure will condition the 
rechargeable cell unit, giving you the 
best possible shaving performance 
and prolonging the life of the re-
chargeable cell unit.

The shaver should not be left in per-
manent charge for several weeks.

Shaving with the mains lead
If your shaver’ s rechargeable cell 
unit is flat (i.e. when you first use the 
shaver or the shaver runs out of 
power) you can connect the shaver 
directly to an outlet in order to shave 
immediately.

If the shaver should, however, not run 
immediately, leave it plugged in with 
switch 

3

set to «off», for approxi-

mately 1 minute. Thereafter, you can 
shave with the mains lead plugged 
into the outlet.

Shaving directly via the special 
charging cord while connected to 
outlets below international standard 
voltages (e.g. cars, boats, etc.) is not 
possible.

Shaving
Remove the foil protection cap 

8

 (a). 

Push switch 

3

up to «on». Hold the 

shaver at right angles to your skin. 
Stretch your skin with your free hand 
(b). Guide the shaver smoothly 
against the direction of beard growth, 
applying only gentle pressure.

Longhair trimming
To use pop- out longhair trimmer 

5

, 

push switch 

2

to setting «longhair 

trimmer».
The longhair trimmer allows easy and 
exact trimming of the side burns (c). 
The longhair trimmer can be switched 
on and off during shaving.

Switching the shaver off
Push the on/ off switch 

3

back all the 

way to setting «off».

Important: After every shave replace 
the foil protection cap 

8

on the foil 

frame 

7

.

Switch lock
To avoid accidentally switching on the 
shaver and discharging the cell unit, 
the switch lock should be turned on 
when travelling. Push switch 

4

all the 

way down to the setting «lock».