Philips HX8911 Sonicare HealthyWhite+ - Инструкция по эксплуатации - Страница 10

 3 

 Press the power on/off and mode button to switch on the Philips 

Sonicare.

 4 

 Apply light pressure to maximise Philips Sonicare’s effectiveness  

and let the Philips Sonicare toothbrush do the brushing for you.  

Do not scrub.

 5 

 Gently move the brush head slowly across the teeth in a small back 

and forth motion so the longer bristles reach between your teeth. 

Continue this motion throughout the brushing cycle.

 6 

 To clean the inside surfaces of the front teeth, tilt the brush handle 

semi-upright and make several vertical overlapping brushing strokes 

on each tooth (Fig. 5).

Note: To make sure you brush evenly throughout the mouth, divide your 

mouth into 4 sections using the Quadpacer feature (see chapter ‘Features’). 

 7 

 Brush each section for 30 seconds for a total brushing time of 2 

minutes. Start with section 1 (outside top teeth) and then brush 

section 2 (inside top teeth). Continue with section 3 (outside 

bottom teeth) and finally brush section 4 (inside bottom teeth)  

(Fig. 6).

 8 

 After you have completed the brushing cycle, you can spend  

additional time brushing the chewing surfaces of your teeth and 

areas where staining occurs. You can also brush your tongue, with 

the toothbrush switched on or off, as you prefer (Fig. 7).

The Philips Sonicare is safe to use on:

 - Braces (brush heads wear out sooner when used on braces).

 - Dental restorations (fillings, crowns, veneers)

Note: Ensure that braces or dental restorations are properly adhered and not 

compromised. If not, braces or dental restorations may be damaged when 

they come into contact with the brush head.
Note: When the Philips Sonicare is used in clinical studies, the default  

2-minute Clean mode with high intensity must be selected. The handle  

should be fully charged and the Easy-start feature deactivated.

ENGLISH

10