Zigmund & Shtain EN 116.622 B - Инструкция по эксплуатации - Страница 20

18

Temperatures display

The 5 bars near to the temperature set indicator 

show the temperature level reached. The arrow 

facing upwards and flashing signals that the oven 

is heating up. After cooking has been interrupted, 

while the temperature inside the oven is above 

60  °C,  a  flashing  downward  arrow  and 

hot

 will 

appear on the display and will remain until the 

temperature drops below 60 °C.

Acoustic signal: the acoustic signal continues 

to ring at the end of a program for approx. 7 

minutes. To stop it, press   or   indifferently. 

It is possible to adjust the volume of the signal 

to three levels: in the 

STOP

 position, operate on 

the 

 symbol, pressing it for approx. 5 seconds 

until the tone level currently set appears. Operate 

on the    symbol again to set the desired level. 

Command tones

It is possible to modify the type of sound emitted 

when operating on the commands.

In the 

STOP

, position, slightly press the   symbol 

for approx. 5 seconds. Operate on the   symbol 

again to select “

bt

” (beep tone), “

c

” (click tone) or 

“

nt

” (no tone)

Energy saving

To limit the waste of electricity, the 

PS

 (Power 

Save) function can be used. This function switches 

the oven off completely if, in absence of cooking 

functions activated, there is no intervention with 

any command. Press and hold the   symbol for 

approx. 5 seconds 

PS on 

will appear. The function 

is now active and the oven will automatically turn 

off after approximately 1 minute. Operate on the 

 symbol to switch it back on..

Child safety

This function allows access to the functionality 

of the electronic programmer keys to be blocked, 

both when the oven is running and when the oven 

is off. 

By operating on the   symbol for 2 seconds, 

this function is activated. This prevents children 

or other persons from pressing the programmer 

keys involuntarily. Thus modifying the previous 

program or from starting the oven that is off.

Every programmer signal that intervenes while 

the oven is on, when the safety lock is activated, 

can be eliminated by pressing any of the boxed 

keys. The safety lock will remain active 

.

NOTE:

  The lock must be deactivated for access 

to a set program.

Error signals

When situations occur that prevent normal 

operation of the oven, the device informs this with 

a series of signals, such as:

Err1:

 communication error – 

Err2:

 PT1000 

(probe) open circuit  – 

Err3:

 PT1000 (probe) 

closed circuit  – 

Err4: 

temperature too high on the 

display – 

Err5: 

temperature too high on the power 

board – 

Err6:

 fault in the display – 

Err7: 

fault in 

the power board

– 

Err8:

 no heating is detected.

For the 

Err4

 and 

Err5

 errors, switch the oven 

off and allow it to cool for a few hours and then 

try to use it again. If the error persists, call the 

technical after-sales assistance. 

If any of the 

other errors are present, the authorised after-

sales assistance must be informed.