Makita DP2010 - Инструкция по эксплуатации - Страница 3

3 

ENGLISH (Original instructions) 

Explanation of general view 

1-1. Switch trigger 
1-2. Lock button 
2-1. Speed control screw 
2-2. Higher 
2-3. Lower 

3-1. Reversing switch 
4-1. Tighten 
4-2. Chuck key 
5-1. Sleeve 
5-2. Ring 

6-1. Depth gauge 
6-2. Washer 
6-3. Clamp screw 

SPECIFICATIONS 

Model DP2010 

DP2011 

Steel 

6.5 mm 

6.5 mm 

Capacities 

Wood 

15 mm 

15 mm 

No load speed (min

-1

) 

0 - 4,200 

0 - 4,200 

Overall length 

209 mm 

222 mm 

Net weight 

  1.0 kg 

1.1 kg 

Safety class 

/II 

/II 

• Due to our continuing program of research and development, the specifications herein are subject to change without notice. 
• Specifications may differ from country to country. 
• Weight according to EPTA-Procedure 01/2003 

ENE032-1 

Intended use

The tool is intended for drilling in wood, metal and plastic. 

ENF002-2 

Power supply

The tool should be connected only to a power supply of 
the same voltage as indicated on the nameplate, and 
can only be operated on single-phase AC supply. They 
are double-insulated and can, therefore, also be used 
from sockets without earth wire. 

ENG905-1 

Noise

The typical A-weighted noise level determined 
according to EN60745: 

Sound pressure level (L

pA

) : 77 dB (A) 

Uncertainty (K) : 3 dB (A) 

The noise level under working may exceed 80 dB (A). 

Wear ear protection

ENG900-1 

Vibration 

The vibration total value (tri-axial vector sum) 
determined according to EN60745: 

Work mode: drilling into metal 
Vibration emission (a

h,D

) : 4.0 m/s

2 

Uncertainty (K) : 1.5 m/s

2 

ENG901-1 

• 

The declared vibration emission value has been 
measured in accordance with the standard test 
method and may be used for comparing one tool 
with another. 

• 

The declared vibration emission value may also be 
used in a preliminary assessment of exposure. 

WARNING: 

• 

The vibration emission during actual use of the 
power tool can differ from the declared emission 
value depending on the ways in which the tool is 
used. 

• 

Be sure to identify safety measures to protect the 
operator that are based on an estimation of 
exposure in the actual conditions of use (taking 
account of all parts of the operating cycle such as 
the times when the tool is switched off and when it 
is running idle in addition to the trigger time). 
 

ENH101-16 

For European countries only 

EC Declaration of Conformity 

We Makita Corporation as the responsible 
manufacturer declare that the following Makita 
machine(s): 

Designation of Machine:   
High Speed Drill 
Model No./ Type: DP2010, DP2011 
are of series production and 

Conforms to the following European Directives: 

2006/42/EC 

And are manufactured in accordance with the following 
standards or standardised documents: 

EN60745 

The technical documentation is kept by:   

Makita International Europe Ltd. 
Technical Department, 
Michigan Drive, Tongwell, 
Milton Keynes, Bucks MK15 8JD, England