Profi Cook PC-TKS 1056 - Инструкция по эксплуатации - Страница 47

47

Scope of delivery

1  Base station

1 Kettle 

1  Tee-/ Coffee maker 

1 Filter

Unpacking of the appliance

1.  Remove the appliance from its packaging.

2.  Remove all the packaging material such as 

foils, filler material, cable holders and cardboard 

packaging.

3.  Check the scope of delivery for completeness. 

4.  In the event that the packaging content should 

be incomplete or if damages should be notice-

able, do not operate the appliance. Return it to 

the dealer immediately.



NOTE: 

There may still be dust or production residue on 

the device. We recommend that you clean the 

appliance as described under “Cleaning”.

Explanation of the control panel

1  Reducing the warm-keeping temperature ( )

2  Increasing the warm-keeping temperature ( )

3  Temperature display 

4  Pilot lamps (TEA / COFFEE)

5  Select the warm-keeping temperature preset by 

the factory for coffee or tea (MOD)

6  Switching on/off the hotplate ( )

Instructions

Location

Put the base on a flat surface.

Preparation
Water kettle:

Before using for the first time, 

boil fresh water at least three 

times in the appliance. Use 

only water without any addi-

tives or ingredients.

Tea/coffee maker: 

Clean the tea/coffee maker 

and filter as usual in soapy 

water. Rinse with clear water 

afterwards. Dry the tea/cof-

fee maker and filter with a 

cloth.

Mains Lead

Completely unwind the required power cord from 

the bottom part of the base. Pay attention to the 

guide of the power cord.

Electrical connection

Check whether the electrical voltage that you intend 

to use is the same as that of the machine. Details 

are to be found on the label on the base.

Connected Wattage

The total power consumption of this device can be 

up to 2500 W. With this connected load a separate 

supply line protected by a 16 A household circuit 

breaker is recommended.

CAUTION: Overload!

•  If you use extension leads, these should have 

a cable cross-section of at least 1.5 mm².

•  Do not use any multiple sockets, as this device 

is too powerful.

Operating the water kettle



NOTE:  

Always use fresh, cold water.

1.  Press the button in the lid to open the kettle. 

The opener will spring open. Remove the lid.

2.  Then fill in the water. Please only fill up to the 

maximum (MAX) mark. You can read the filling 

level on the water level indicator of the kettle. 

3.  Place the lid onto the appliance. Press the but-

ton in the lid to close the lid. The button must 

click in audibly.

4.  Put the water kettle onto the connecting joint of 

the base.