Ardesto EKL-X50 - Инструкция по эксплуатации - Страница 14

14

EN

•  Use only purified water.

•  Do not overfill the kettle over the Max level because 

boiling water being ejected from the spout while 

operating. The minimum amount of water should reach 

the Min marking.

•  Fill with the desired amount of water and close the lid. 

To close lid simply press the lid.

•  Place the kettle filled with water on the base.

•  Connect the power cable to the mains and turn on the 

kettle by pressing the switch, after which the indicator 

light will light up.

•  The kettle will turn off automatically when the water is 

boiling.

•  After boiling, allow the kettle to cool for 5 minutes 

before refilling with water.

•  Avoid sudden temperature changes when filling the 

kettle with water. Do not fill a hot kettle with cold water 

or a cold kettle with hot water.

•  Condensation may form on the surface of the base. It 

is formed during the automatic shutdown of the kettle 

due to the release of steam through the vents in the 

base of the kettle. Before reuse, remove condensation 

from the surface of the base with a tissue.

USEFUL NOTES

•  To prolong the life of the kettle, do not leave the water 

overnight, empty the water after use.

•  If you accidentally turn on an empty kettle, when the 

kettle is heated, the protection against operation 

without water will work, the kettle will turn off. Let the 

kettle cool for 10 minutes before refilling it with water.

•  Attention: 

Frequent switching on of the device 

without water may damage the protection system, so 

always check that there is water in the kettle before