Блендеры VITEK VT-8513 G - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
3
ENGLISH
BLENDER VT-8513 G
The table blender is intended for chopping
products, mixing different ingredients or mak-
ing cocktails.
DESCRIPTION
1.
Measuring cup
2.
Blender bowl lid
3.
Blender bowl
4.
Ring gasket
5.
Knife block
6.
Motor unit
7.
Operation mode switch «
P
–
0
-
1
-
2
»
8.
Non-slip feet
SAFETY MEASURES
Read this instruction manual carefully before
using the unit and keep it for the whole unit
operation period.
Use the unit for intended purposes only, as
specified in this manual. Mishandling of the unit
may lead to its breakage and cause harm to the
user or damage to his/her property.
•
Before using the unit for the first time, make
sure that the voltage in your mains corre-
sponds to the voltage of the unit.
•
Do not use the unit outdoors.
•
Place the unit on a flat steady surface.
•
Use only the removable parts supplied with
the unit.
•
Always unplug the unit before cleaning or if
you are not using it.
•
The knives’ cutting edges are very sharp and
dangerous. Handle the knives very carefully
when dismantling the unit or removing pro-
cessed food from the blender bowl and dur-
ing cleaning!
•
In case the knives suddenly stop rotating,
unplug the unit before removing the ingredi-
ents which block the knives’ rotation.
•
Do not overfill the blender bowl with prod-
ucts and watch the level of liquids.
•
Remove products and pour out liquids from
the blender bowl only after complete stop of
the knives, after you switch off and unplug
the unit.
•
Put the products into the blender bowl
before the unit is switched on. Do not switch
the unit on without food in the bowl.
•
Cool down hot products before using the unit.
•
Before using the unit, make sure that the
blender bowl, the knife block and the
blender bowl lid are set properly. Do not
switch the unit on if the blender bowl lid is
not installed.
•
Do not touch the rotating parts of the unit.
Do not let hair or free hanging clothes get
into the rotation area of the knife.
•
When disconnecting the power plug from
the mains, do not pull the cord, but hold the
plug with your hand.
•
Do not let the power cord hang from the
edge of the table and make sure it does not
touch hot surfaces or sharp edges of fur-
niture.
•
Do not touch the power plug with wet hands.
•
Do not leave the operating unit unattended.
•
Do not use the unit near a kitchen sink; do
not expose the unit to moisture.
•
Do not use the unit in places where aero-
sols are sprayed or highly flammable liquids
are used.
•
Do not use the unit next to heat sources or
open flame.
•
To avoid electric shock, do not immerse the
power cord, the power plug and the motor
unit in water or any other liquids.
•
Do not allow children to touch the motor
unit and the power cord during the blender
operation.
•
Do not leave children unattended to prevent
using the unit as a toy.
•
During the unit’s operation and breaks
between operation cycles, place the unit
out of reach of children.
•
The unit is not intended for usage by physi-
cally or mentally disabled persons (including
children) or by persons lacking experience
or knowledge if they are not under supervi-
sion of a person who is responsible for their
safety or if they are not instructed by this
person on the usage of the unit.
•
For children safety reasons do not leave
polyethylene bags used as a packaging
unattended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
•
To avoid damages, transport the unit in the
original package only.
•
Periodically check the power cord and the
plug: they should not be damaged.
•
Do not use the unit if the motor unit body,
the power cord or the plug is damaged,
IM VT-8513.indd 3
25.04.2016 10:02:09
