Philips HR1720 - Инструкция по эксплуатации - Страница 9

E N G L I S H

9

3

Make sure that the appliance is plugged in.

How to use the filter

1

Place the lid (F) on the blender jar

.

2

Put the ingredients in the filter (fig. 7). Do not fill the filter beyond the top of the sieve mesh.

Cut fruits into smaller pieces and soak dr y ingredients, such as soy beans, before putting them in filter.

3

Pour water or another liquid (milk, juice, etc.) into the blender jar.

4

Insert the measuring cup (G) into the hole in the lid.

Let the appliance run for approx. 40 seconds.

5

Switch the appliance off and remove the blender jar from the motor unit.

6

Pour the drink out via the pouring lip of the blender jar (fig. 8).

Do not remove the lid, the measuring cup and the filter.

.

7

For optimal results, put the jar with the remaining ingredients back onto the appliance and
let it run for a few more seconds.

Note: when you are processing a large quantity, we advise you not to put all the ingredients in the
filter at the same time. Star t processing a small quantity and let the appliance run for a few seconds.
Then switch the appliance off and add another small quantity, but do not exceed the top of the
sieve mesh. Repeat this procedure until you have processed all the ingredients. Always keep the lid
on the blender jar during processing.

Soy milk

This recipe can only be prepared with the filter.

Do not process more than two batches without interrruption. Let the appliance cool down to
room temperature before continue processing.

Ingredients
-

50g dr y soy beans

-

500ml water

B

Soak the soy beans for 4 hours before processing them. Set aside to drain.

B

Put the soaked soy beans in the filter. Pour 500ml of water into the blender jar and blend for 
40 seconds.

B

Pour the milk into a pan.

B

Bring the soy milk to the boil, then add sugar and leave to simmer until all the sugar has melted.

B

Ser ve hot or cold.

Mill 

Only types HR 1721 and HR 1727

How to use the mill

1

Put the ingredients in the jar (H) (fig. 9).

You can process wet and dr y ingredients.

2

Do not fill the jar beyond the "MAX" indication.

3

Put the larger sealing ring (I) on the blade unit of the mill (J) (fig. 10).

Make sure that the rubber sealing ring has been placed correctly.

4

Screw the blade unit on the jar by turning it clockwise (fig. 11)

5

Hold the assembled mill upside down and screw it onto the motor unit (A) by turning it
clockwise until you hear a 'click' (fig. 12) .

6

Make sure that the appliance is plugged in.