BRAYER BR1247 - Инструкция по эксплуатации - Страница 9

9

EN

•  The attachment is used to chop meat, cheese, onion, 

herbs, garlic, carrots, walnuts, prunes, vegetables 

or fruit.

ATTENTION! 

Do not chop very hard products, such as 

nutmegs, coffee beans, cereals, frozen food or ice.

PREPARING THE FOOD BEFORE CHOPPING:

•  Remove bones, veins, cartilage and fat from meat.

•  Cut meat, cheese, onions, vegetables or fruit into 

pieces approximately 60x20x20 mm in size. Maximal 

weight of the meat should not exceed 250 g.

•  Remove stems of herbs, shell nuts.

CHOPPING

Before assembling the chopper, make sure that the 

power plug is not inserted into the mains socket.

• 

Place the chopper bowl (10) on a flat and steady 

surface.

•  Install the chopping knife (9) on the axis inside the 

bowl (10). If there is a protective lid, carefully remove 

it before installing the chopping knife (9).

ATTENTION! 

The blades of chopping knife (9) are very 

sharp! Always hold the chopping knife (9) by the plastic 

end.
•  Put the products into the bowl (10).

• 

Note:

 — do not switch the unit on when the bowl (10) 

is empty.

•  Install the geared lid (8) on the bowl (10).

•  Install the motor unit on the geared lid (8) feeding 

chute, make sure that the motor unit is fixed properly. 

Install the motor unit evenly in vertical position (fig. 

2).

•  Insert the power plug into the mains socket.

•  To switch the unit on, press and hold down the button 

(4) « ».

•  When you press and hold the button (4) « » you 

can control the chopping knife (9) rotation speed by 

turning the control knob (5).

•  For operation at the maximal rotation speed, press 

and hold down the button (3) «TURBO».

•  During the unit operation hold the motor unit with one 

hand and the chopper bowl (10) with the other hand.

• 

Release the button (3 or 4) to switch off.

•  After the unit operation, wait till the chopping

•  knife (9) completely stops rotating.

•  Remove the power plug from the mains socket.

•  Disconnect the motor unit from the geared lid (8) by 

pressing the release buttons (2) (pic. 2).

•  Remove the geared lid (8) from the bowl (10).

•  Carefully remove the chopping knife (9) from the 

bowl (10) holding it by the plastic end.

•  Take the chopped products out of the bowl (10).