Акустика Sven OMNI - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
ENG
16
2.0 USB Multimedia
Speaker System
Value
4 (2 × 2)
120 – 18,000
Ø 50
5 D
С
/USB
132 × 54 × 132
0.6
Parameter, measurement unit
Output power (RMS), W
Frequency range, Hz
Speaker diameter, mm
Power supply, V
Dimensions (one speaker) (W × H × D), mm
Weight, kg
7. TECHNICAL SPECIFICATIONS
Notes:
•
Technical speci
fi
cations given in this table are supplemental information and cannot give
occasion to claims.
•
Technical speci
fi
cations and package contents are subject to change without notice due
to the improvement of SVEN production.
•
Plug the connector of the USB power cable to the power cable jack DC IN
c
, than plug the other
connector of the USB power cable to a USB-port of your laptop, PC or 5V DC power supply.
•
Set volume level to minimum by turning volume control wheel
h
counterclockwise until it stops.
•
Turn on PC power supply, turn on the audio source. The speaker bases and volume control wheel
are illuminated during the whole MSS operation.
•
Adjust volume level by turning VOLUME control wheel
h
.
Notes:
•
After
fi
nishing operating the MSS, mind to turn off the USB-cable from the PC, laptop
USB port or 5V DCV power supply.
•
To enhance sound quality, use a sound card Line-Out output.
6. TROUBLESHOOTING
If none of the above methods can solve the problem, please seek professional advice at your
nearest service center. Never attempt to repair the product yourself.
Problem
MSS does not
turn on.
No sound.
Sound of speakers
is too quiet.
Distortion of
sound.
Cause
MSS is not connected to the mains outlet.
Power switch is o
ff
.
Volume level is set at minimum value.
Improperly connected audio source.
Volume level is set at minimum value.
Large amplitude of the input signal.
Solution
Check the connection.
Turn on the switch.
Adjust the volume control knob.
Connect audio sources correctly.
Adjust the volume control knob.
Turn down the source volume
and MSS volume.
