Акустика Sven MS-230 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
If none of the above mentioned solutions removes the problem, please refer to your nearest
authorized service center. Never try to repair the device on your own.
6. TROUBLESHOOTING
Problem
The MSS does not
turn on.
No sound.
The sound of speakers is
too quiet.
Distortion of sound.
Sound is produced by
one of the channels only.
Cause
The MSS isn’t connected to a mains outlet.
The power switch is o
Ԛ
.
Volume level is set at minimum value.
Improperly connected audio sources.
Volume level is set at minimum value.
Large amplitude of the input signal.
The speakers are improperly connected to
the audio source.
Solution
Check the connection.
Turn on the switch.
Adjust volume control knob.
Connect the audio sources
correctly.
Adjust volume control knob.
Turn down the source
and MSS volume.
Check the connection of
speakers.
•
Adjust the volume level by turning the VOLUME control knob
g
. While turning the knob
clockwise, you increase the volume level, but while turning it counterclockwise, you reduce it.
•
Adjust the treble and bass levels by turning the TREBLE control knob
h
and BASS control knob
f
accordingly. While turning the knobs clockwise, you increase the treble and bass level, but while
turning the knobs counterclockwise, you reduce it.
Notes:
• After using the MSS, mind to shift the POWER switch
e
into the OFF position, and unplug
the power cord
l
.
• To enhance the sound quality, use the Line-Out port of your sound card.
ENG
19
Operation Manual
MS-230
