SVEN MS-2085 - Инструкция по эксплуатации - Страница 20

2.1 Multimedia Speaker System 

ENG

20

l

 TUN +/-: manual band scanning (in the Radio mode)

m

 VOL+/-:  volume level control

n

,   : Previous/Next track (in the Player and Bluetooth 

mode); previous/next station (in the 

Radio

 mode);

ON/OFF   backlight (pressed long)

o

, AUTO: Play/Pause (in the Player and Bluetooth mode);

start/stop auto scan (pressed long in the 

Radio

 mode)

p

 0-9: numeric pad 

(select track number in the Player mode 

or track number FM Radio)

Battery Installation

• 

Open the battery compartment on the back of the remote 

control.

• 

Insert the included AAA batteries. 

• 

Close the battery compartment. 

Notes:

• Use the RC at an angle no more than 30° at a distance of no 

more than 7 meters.

• Direct the remote control at the LED display on the 

subwoofer.  

• If the remote control does not work, check the batteries or 

replace the discharged batteries with new ones.

• Remove the batteries from the RC if you don’t intend to use 

it for a long time.

5. PREPARATION AND OPERATION

Speaker placement

• 

Place the speakers symmetrically to the listener at least one 

meter  away.  The  subwoofer  emits  non-directional  sound, 

therefore  it  can  be  located  in  any  place  of  the  room  where  it 

sounds the best.

• 

Place MSS far away from monitors and TV sets, as insignificant 

image distortion in these supersensitive devices is possible.

Fig. 4. Remote

control

Installation and operation

MS-2085 speaker system can be connected to virtually any audio devices: МР3 player, PCs, laptops, 

etc. (see connection diagram in Fig. 5).

• 

Before  making  any  connections,  make  sure  the  MSS  is  off  and  unplugged.  Connect  the  right 

speaker to the subwoofer AUDIO OUTPUT R with the built-in audio cable and the left speaker – to 

the AUDIO OUTPUT L. 

• 

To use satellites backlight, connect the built-in cable of each satellite to the connectors LED1

f

/

LED2 

g

. 

• 

To connect the MSS to a PC, МР3 player, use a 2RCA to mini-jack signal cable (included). Insert the 

RCA jacks of the signal cable into the L and R jacks of the PC AUDIO INPUT 

l

, and the mini-jack of 

the signal cable – into the LINE OUT port of your PC sound card or an audio output of your МР3  

player, as shown in Fig. 5.

k

 REPEAT: repeat mode selection button (in the Player mode): 

ONE – repeats the current track;

ALL – plays all tracks in the sequential order