Акустика Sven HT-435D - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.

you want - we can
ENG
5.1 Active Home Theater
Speaker System
26
Fig. 3. Remote control
5. PREPARATION AND OPERATION
Speaker placement
•
To achieve optimum sound, it’s recommended that you place the
speakers according to Fig. 5. The center and front speakers should
be located along an imaginary circle with the distance between the
listener and the center channel speaker as a radius, and the lis-
tener’s head as the center. Each of the three speakers should be
placed at equal distance from the listener. The front speakers and
the listener make up an equilateral triangle. The rear speakers are
placed at the same distance from the listener (on the imaginary
circle, too) at an angle of nearly 110° to the Listener – Display axis.
•
Avoid placing your speakers in the corners and close to walls, as this can lead to unwanted resonance
and distortions. If possible, place them at least 20 cm away from walls.
•
For more accurate perception, the tweeters should be at the listener’s ear level.
•
Do not locate the speakers in niches. Such placement can affect the sound badly, especially in the lows.
•
The subwoofer emits non-directional sound, therefore it can be located in any place of the room where
it sounds the best.
Fig. 4. Battery installation
Remote control
a
STANDBY: off/on button (standby mode)
b
OPT: optical input button
c
COAX: coaxial input selection button
d
2.1/5.1: mode selection button
e
FRONT+/-: front channel volume control buttons
f
CENTRE +/-: center channel volume control buttons
g
SUB-/+: subwoofer channel volume control buttons
h
VOLUME -/+: master volume control buttons
i
MUTE: sound off/on button
j
AUX: additional stereo input button
k
RESET: return to default settings
l
REAR+/-: surround speakers channel volume control buttons
Remote control battery installation
•
Open the battery compartment on the back of the remote control.
•
Insert 2 AAA type batteries (included).
•
Close the battery compartment.
Notes:
• Use the remote control at an angle of no more than 30°, no more
than 7 meters away.
• Direct the RC at the IR receiver display on the subwoofer.
• If the remote control does not work, check the battery or replace
the discharged battery with a new one.
• Remove the battery from the remote control if you don’t intend
to use it for a long time (more than a week).
a
i
b
j
c
k
d
l
e
f
g
h
Содержание
- 3 Руководство по эксплуатации; ТЕХНИЧЕСКОЕ ОПИСАНИЕ; Внимание! Внутри корпуса на элементах без изоляции имеется
- 4 Активная акустическая система 5.1; Особенности АС
- 5 Задняя панель
- 6 Пульт дистанционного управления; • Если ПДУ не работает, проверьте наличие элементов; ПОДГОТОВКА И ПОРЯДОК РАБОТЫ; элементов питания
- 7 щайте АС на расстоянии не менее 20 см от стен.; Подключение колонок к сабвуферу; сети. На сабвуфере следует уменьшить громкость.
- 8 Работа системы; дорожки. При этом в формате DD5.1 индикатор; комендуется выключатель POWER
- 10 УСТРАНЕНИЕ НЕИСПРАВНОCТЕЙ
- 11 ТЕХНИЧЕСКИЕ Х АРАКТЕРИСТИКИ
- 32 ® Registered Trademark of Oy SVEN; Активная акустическая система