Zanussi ZHP60350SA - Инструкция по эксплуатации - Страница 2

2

SAFETY WARNING

▪

The minimum distance between the hob surface on which the pans stand 
and the lower part of the hood must be 65 cm, unless otherwise speci

fi

 ed 

in the installation instructions. If the hob installation instructions specify a 
greater distance, it must be taken into account.

▪

The air collected must not be conveyed into a duct used to blow off 
smokes from appliances fed with an energy other than electricity (central 
heating systems, thermosiphons, water-heaters, etc.).

▪

Comply with the of

fi

 cial instructions provided by the competent autho-

rities in merit when installing the disposal duct. In addition, exhaust air 
should not be discharged into a wall cavity, unless the cavity is designed 
for that purpose.

▪

The room must be well aerated in case a hood and some other heat 
equipment fed with an energy other than electricity (gas, oil, coal heaters, 
etc) operate at the same time. 

▪

In fact the intake hood, disposing of air, could create a vacuum in the 
room. The vacuum should not exceed 0,04mbar. This prevents the gas 
exhausted by the heat source from being intaken again. It is therefore 
advisable to ensure the room contains air taps able to ensure a steady 

fl

 ow of fresh air.

▪

Check the data label inside the appliance; if the symbol ( ) is printed, 
read the following: this appliance has such technical particulars that it 
belongs to class II insulation, therefore it must not be earthed.

▪

Check the data label inside the appliance; if the symbol ( ) is NOT prin-
ted, read the following:   ATTENTION: This appliance must be earthed. 
When making the electrical connections, check that the current socket 
has a ground connection.

▪

When making the electrical connections, check that the voltage values 
correspond to those indicated on the data plate inside the appliance 
itself. In case your appliance is not 

fi

 tted with a supply cord and a plug or 

with other  means for disconnection from the supply mains having a con-
tact separation in all poles that provide full disconnection under overvol-
tage category III conditions, that means for disconnection must be incor-
porated in the 

fi

 xed wiring in accordance with the wiring rules. If your unit 

features a power lead and plug, position this so the plug is accessible.

▪

Always switch off the electricity supply before carrying out any cleaning