Viking EVWH53048CS - Инструкция по эксплуатации - Страница 7

7

Maintaining Charcoal Filter (Recirculating Hoods Only)

Replace the charcoal filters every 6 months to 1 year depending on the amount and type of cooking
you do.

To replace, remove the baffle/charcoal filter assembly and slide the charcoal filter out of the channel and
replace with a new one. Do not put the charcoal filters in the dishwasher.

Replacement filters are available through your local Viking Range dealer, or you can call the Viking
Online Store at  1-877-834-8222 or visit vikingrange.com.

CAUTION

For general ventilating use only. DO NOT use to exhaust hazardous or
explosive materials and vapors.

Cleaning and Maintenance

Cleaning Hood Canopy

Finishes in enamel or stainless steel are highly resistant to damage or discoloration due to grease, steam, and heat—
provided that reasonable care is given to the equipment. The following suggestions will help keep your hood looking new.

1. Do not allow an excessive accumulation of grease. For best results, you should wipe your hood clean with a cloth dipped in

warm, soapy water. DO NOT USE ABRASIVE CLEANSERS, STEEL WOOL PADS, OR ABRASIVE CLOTHS. DO NOT use cleansers that
contain chlorides; the chlorides in the cleaner could damage the stainless steel finish. If you need to scrape stainless steel to
remove encrusted materials, first soak the area with hot towels to loosen the material, then use a wooden or nylon spatula or
scraper. DO NOT use a metal knife, spatula, or any other metal tool to scrape stainless steel.

2. Every 3 months give your hood a thorough cleaning. On painted surfaces, use a new coat of wax. A good wax cleaner—

available at either a grocery or hardware store—will do both jobs at once. On stainless steel surfaces, use a good stainless
steel cleaner and polish.

Renewing Enamel Finish

If discoloration occurs, you should thoroughly polish

the finish on your hood to renew its gloss and luster and to remove any grease residue which may have a yellowing effect.
Use any good enamel polish, refrigerator polish, or automotive polish.

Renewing Stainless Steel Finish

Regular cleaning is the best way to assure that your stainless steel finish stays bright and unscratched. Use lemon oil or
stainless steel polish to coat and protect stainless steel.

Cleaning Ductless Venting Chamber (Professional Hoods Only)

1. Remove the middle vent by gently raising up and pulling out.
2. Use the same cleaning directions as in “Cleaning the Hood Canopy” section.
3. After cleaning, replace the middle vent.

Replacing the Light Bulbs

When removing bulbs use an oven mitt to protect your hand in case the bulb breaks.

CAUTION

Do not use a porcelain cleaner or rough abrasive cleaner.