Teka DPL 90 - Инструкция по эксплуатации - Страница 11

•

If your kitchen hood is made of stainless steel, 

use proprietary cleaners mentioned in the 

product instructions.

•  If  your  kitchen  hood  is  painted,  use  lukewarm 

water and a neutral soap. 

•  Never  use  metallic  scourers,  nor  abrasive  or 

corrosive products.

•  Dry the kitchen hood using a cloth that does not 

produce fibres.

•  Do not use vapour cleaners.

To remove the filters from their fittings, press lightly 

on the locks and then pull them off.

The metal filters can be cleaned by soaking them 

in hot water with neutral detergent until the fat 

dissolves and then rinsing them under the tap 

or using special anti-grease products. They can 

also be washed in a dishwasher. In this case, it 

is advisable to stack them vertically to avoid food 

residues to stick to them.

Cleaning in a dishwasher may damage the metallic 

surface  (blackening  it),  although  this  will  not  affect 

its fat retention capacity.

Once clean, leave them to dry off and then fit them 

onto the kitchen hood.

The manufacturer reserves the right to make changes and corrections to its products as it deems 

necessary, without altering their basic characteristics.

Problem solving

Proceed with the following checks before calling the Technical Service:

Active charcoal filters (Optional)

When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air 

by recycling it through active charcoal filters.
The active charcoal filters have an active life of between three to six  months, depending on 

the individual conditions of use. These filters cannot be washed nor regenerated. They must be 

replaced once their useful life comes to an end.

GB

Problem

Possible  cause                           

 Solution

The kitchen hood does not 

work.       

The mains cable is not 

connected  to  the  network.        

There is no current in the netw

ork.

Connect the mains cable to the 

network.

Provide current to the network.

The kitchen hood does 

not extract sufficiently or 

vibrates.

Filters  are  saturated  with  fat.     

Obstruction in the air outlet.

Change or clean the active 

charcoal and/or metal filters.

Remove the obstruction.

Adjustment of the clock

During cleaning and maintenance work, make sure 

the safety instructions are complied with

.

Cleaning the hood body

Cleaning and maintenance

1) Push the on/off’ button for 3 seconds.
2) Adjust the hour digits by pressing ‘+’ or ‘-’.
3) Push the on/off’ button again.
4) Adjust the minute digits by pressing ‘+’ or ‘-’.

5) After 3 seconds your settings are saved 
automatically.

Cleaning the metal filters

Changing light bulbs

For changing the light bulbs please contact the 
manufacturer’s nearest Technical  Service.

Filter saturation indicator “F”

When the sign ‘Saturation of the filters’ is on, the filters 
should be cleaned.
After cleaning the filters, simultaneously push “+” and 
“-” for at least 3 seconds whereupon the sign will be 
switched off.