Teka DJE 60 - Инструкция по эксплуатации - Страница 9

The manufacturer reserves the right to make changes and corrections to its products as it
deems necessary, without altering their basic characteristics.

During cleaning and maintenance work, make
sure the safety instructions are complied with.

• If your kitchen hood is made of stainless

steel, use proprietary cleaners mentioned
in the product instructions.

• If your kitchen hood is painted, use

lukewarm water and a neutral soap. 

• Never use metallic scourers, nor abrasive

or corrosive products.

• Dry the kitchen hood using a cloth that

does not produce fibres.

• Do not use vapour cleaners.

To remove the filters from their fittings, press
lightly on the locks and then pull them off.

The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.

Proceed as follows:
• Unscrew the lamp cover.
• Change the broken / burnt out lamp. 
• Screw the lamp cover back in.

Cleaning the metal filters

Cleaning the hood body

Cleaning and maintenance

Problem solving

Proceed with the following checks before calling the Technical Service:

Changing light bulbs

Active charcoal filters (Optional)

When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air
by recycling it through active charcoal filters.

The active charcoal filters have an active life of between three to six  months, depending on the
individual conditions of use. These filters cannot be washed nor regenerated. They must be
replaced once their useful life comes to an end.

GB 

Problem

Possible cause                           

Solution

The kitchen hood does not

work.       

The mains cable is not connected

to the network.        

There is no current in the network.

Connect the mains cable to the

network.

Provide current to the network.

The kitchen hood does not

extract sufficiently or vibrates.

Filters are saturated with fat.     

Obstruction in the air outlet.

Change or clean the active

charcoal and/or metal filters.

Remove the obstruction.

The lamps do not light up. 

The lamps are blown.                                

The lamps are slack.       

Change the lamps.

Tighten the lamps.