Neff D99W45N1 - Инструкция по эксплуатации - Страница 23

23

Replacing the light bulbs

If you encounter a problem

If an 

#

appears in the display:

❑

See "Filters and maintenance" Section.

If is not possible to operate the extractor
hood:

❑

Disconnect the extractor hood from the
mains electricity supply by pulling out the
plug or switching it off at the main fuse
box.
Wait for approx. 1 minute and then
switch it on again.

If you have any questions or if a fault
occurs, please call Customer Service. 

(See list of Customer Service 
representatives).

When you call, please quote the following:

E-Nr.                       FD

Enter the relevant numbers into the box
above. The E-Nr. (product no.) and FD
(production date) are shown on the 
nameplate which can be seen inside the
extractor hood after the filter frame has
been detached.

The manufacturer of the extractor

hoods accepts no liability for complaints
which can be attributed to the design
and layout of the pipework.

1.

Switch off the extractor hood and pull
out the mains plug or switch off the
electricity supply at the fuse box.

When switched on, the halogen bulbs

become very hot. Even for some time after
the bulbs have been switched off there is
still a risk of burns.

2.

Remove the bulb ring with a screwdriver
or similar tool.

3.

Replace the halogen light bulb 
(conventional halogen bulb, 12 Volt,
max. 20 Watt, G4 cap).

Caution:

Refer to for plug-in

lampholder.
Take hold of the bulb with a clean cloth..

4.

Re-insert the bulb ring.

5.

Plug the appliance into the mains or
switch it on at the fuse box.

Note: I

f the light does not function, check

that the bulbs have been inserted correctly.