Kuppersberg T 601 С - Инструкция по эксплуатации - Страница 3

3

English

TEchnical passporT

Wall cooker hoods

1.  A P P E A L  TO  T H E 

C U S TO M E R

Dear Customer,

Congratulations on your choice. We 

are certain that this modern, functional 
and practical device made with fi rst rate 
quality materials will fully satisfy your 
require-ments.

Please read all the sections in this 

INS-TRUCTION MANUAL before using 
the  hood  for  the  fi rst  time  in  order  to 
obtain maximum performance from 
the device and avoid faults which may 
arise from incorrect use as well as 
minor problem solving. For optimal 
performance, the external duct should 
not exceed FOUR METRES, have more 
than two 90 ° angles and its diameter 
should be at least 0120.

2.  I M P O RTA N T  S A F E TY 

I N S T R U CT I O N S

Â

Disconnect the device before 

performing any work on the interior, e.g. 
during cleaning or maintenance.

Â

The excessive accumulation of 

grease in the hood and metal fi lters may 
cause  dripping  and  fi re  risks,  therefore 
it is necessary to wash the inside of the 
hood and the metal fi lters at least once 
a month.

Â

This device can be used by 

children aged 8 and over and persons 
with reduced physical, sensory or mental 
capabilities or lack of experience and 
knowledge, if they have been given 

supervision or proper training in the safe 
use of the device and if they understand 
the dangers in volved. Children should 
not play with the device. Cleaning and 
maintenance should be performed 
by the user and not by un-supervised 
children.

Â

Check that the power voltage and 

frequency match those indicated on the 
label located on the inside of the hood. 
A suitable earth must be connected 
(except for Class II devices, marked with 
0 on the technical data plate). 

Â

 For installation, a connection 

method  isolated  from  the  fi xed 
installation should be incorporated, in 
accordance with installation regulations 
(adjusted to the strength to be 
endured and with a minimum opening 
between the contacts of 3mm) under 
overvoltage category III conditions, for 
the emergency shutdown, cleaning or 
light replacement. In no event should 
the earth pass through this switch. This 
switch can be replaced with a plug if it 
is accessible in normal use.

Â

If the power lead is damaged it 

must be replaced by the manu-facturer, 
its  after-sales  service  or  by  qualifi ed 
personnel in order to avoid potential 
danger.

Â

Air should not be extracted 

by ducts used to expel fumes from 
equipment powered by gas orother 
fuels.

Â

The room must be adequately 

ventilated when the hood will be