Gorenje WHI 643 ORA W - Инструкция по эксплуатации - Страница 33

             EN 33

The saturation indicator of the charcoal filter is normally disabled. To activate it, proceed in the 
following manner:

With the display on (ON) and the suction off (OFF), press simultaneously the buttons 

T8

 and 

T9

for more than 3 seconds; the button 

T9

 lights on with steady light for approx. 5 seconds, to indi-

cate the activation.

To disable it, repeat the operation; the button 

T9

 will flash for approx. 5 seconds to indicate the 

disabling.

Setting of Automatic Operation parameters

For correct use of the automatic operation, perform “Hood Calibration”.

Hood Calibration

With the display on (ON) and the suction off (OFF), press button 

T3

 for 3 seconds.

The suction speed (power) 1 starts functioning and button 

T3

 flashes to indicate that hood calibration 

is initiated and it will last for approx. 5 minutes.

Note: 

to interrupt the calibration, press 

T3

 for 5 seconds; the calibration will be invalidated and should 

therefore be repeated.

MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical 

supply by switching off at the connector and removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the plug must be removed 

from the socket.

Cleaning

The cooker hood should be cleaned regularly (at least with the same frequency with which you carry 
out maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neu-
tral liquid detergent. Do not use abrasive products. 

DO NOT USE ALCOHOL!

WARNING:

 Failure to carry out the basic cleaning recommendations of the cooker hood and replace-

ment of the filters may cause fire risks. Therefore, we recommend observing these instructions. The 
manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inap-
propriate maintenance or failure to observe the above safety recommendations.

Grease filter

Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive 
detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short 
cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its 
filtering capacity. To remove the grease filter, pull the spring release handle.

Charcoal filter

 (filter version only)

It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more 
or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease 
filter. In any case it is necessary to replace the cartridge at least every four mounths. 

Replacing lamps

The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an opti-
mum lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical 
energy.

For replacement, contact the technical service.