Gorenje BHP643ORAW - Инструкция по эксплуатации - Страница 32

EN 32               

OPERATION

Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker 

hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and 

for another 15 minutes approximately after terminating cooking.

To select the functions of the hood just lightly touch and hold control.

T1.  Standby mode 

(the control panel off  all functions disabled) / 

ON

 (control panel switched on)

Note: 

After about a minute of inactivity (suction and lights), the hood will automatically switch to 

standby.

T2.  ON/OFF lights

Press again to turn off  the lights.

T3.  ON/OFF Automatic operation “AdaptTech”

The hood automatically sets the suction speed (power) to increase if the environmental conditions 

detected by the hood sensor require it.

If there are no variations in the environmental conditions, after 10 minutes (if the hood is already in 

suction speed (power) 1), the hood turns off .

Note: 

for a correct use of this function, fi rst perform the “Setting of the parameters for Automatic 

Operation” (see corresponding paragraph).

Note: 

During automatic operation, if the user acts on the other functions that adjust the speed, auto 

ventilation function is switched off .

T4.  Manual selection of the suction speed

 (power):

L1: 

suction speed (power) 1

L2:

 suction speed (power) 2

L3:

 suction speed (power) 3

Press again to turn off  the hood (OFF).

Note: 

manual selection excludes any other suction related set function.

T5.  ON/OFF Intensive suction speed

 (power) 

„POWER BOOST”

 (timed)

Note:

 After 5 minutes of operation the hood returns to its previous state.

T6. ON/OFF 

operation mode 

“Refresh”

Every 50 minutes of inactivity, the suction speed (power 1 is turned on for 10 minutes.

T7.  ON/OFF Delayed switch off  of the suction speed

 (power) (approx. 30 minutes

Note: 

this function is available for the speeds that can be selected with button 

T4

.

T8.  Indicator and reset fi lter saturation

The button lights on automatically with steady light when it is necessary to perform the grease fi lter 

maintenance. The button lights on automatically with fl ashing light when it is necessary to perform 

the charcoal fi lter maintenance.

After performing the maintenance, with the hood off  and the button active, press the button for 

more than 3 seconds to perform the reset of the fi lter saturation indicator; repeat the operation if 

necessary (for ex., when both fi lters are saturated).

Activation of the charcoal fi lter saturation indicator

The saturation indicator of the charcoal fi lter is normally disabled. To activate it, proceed in the 

following manner:

With the display on (ON) and the suction off  (OFF), press simultaneously the buttons 

T7

 and 

T8

 for 

more than 3 seconds; the button 

T8

 lights on with steady light for approx. 5 seconds, to indicate the 

activation.

To disable it, repeat the operation; the button 

T8

 will fl ash for approx. 5 seconds to indicate the 

disabling.