Gorenje BHP62CLI - Инструкция по эксплуатации - Страница 23

23

Otherwise put a thick, protective covering over countertop, cooktop or range to protect from damage and debris. Select a fl at surface 

for assembling the unit. Cover that surface with a protective covering and place all canopy hood parts and hardware in it. 

•

In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket 

is available and it is possible to connect a fumes discharge device to the outside (only suction version). 

•

Carry out all the masonry work necessary (e.g. installation of an electric socket and/or a hole for the passage of the discharge tube). 

Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualifi ed technician must verify suitability 

of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, 

grout or silicone this appliance to the wall. Surface mounting only.

OPERATION

Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 

5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.

1.  The motor is ON/The motor is OFF

If you press the button when the ventilation hood in operation, the appliance is OFF

2.  2,3 increase of the speed

If you press the button the hood is ON and takes the speed 1

If you press the button (the hood is ON) the speed of the motor increases from 1 to more intensive

Speed 1:1

Speed 2:2

Speed 3:3

3.  Lights are ON/OFF

MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the 

connector and removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.

CLEANING

The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat fi lters) inter-

nally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. 

DO NOT USE ALCOHOL!

WARNING:

 Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the fi lters may cause fi re risks. 

Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any damage to the motor or any fi re 

damage linked to inappropriate maintenance or failure to observe the above safety recommendations.

GREASE FILTER

Traps cooking grease particles. The grease fi lter must be cleaned once a month using non aggressive detergents, either by hand or in the 

dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease fi lter may discolour slightly, 

but this does not affect its fi ltering capacity. To remove the grease fi lter, press it and pull it down.

CHARCOAL FILTER

 (fi lter version only)

It absorbs unpleasant odours caused by cooking. The saturation of the charcoal fi lter occurs after more or less prolonged use, depending on 

the type of cooking and the regularity of cleaning of the grease fi lter. In any case it is necessary to replace the cartridge at least every four 

mounths. The charcoal fi lter may NOT be washed or regenerated.

REPLACING LAMPS

The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum lighting, a duration up to 10 times 

as long as the traditional lamps and allow to save 90% electrical energy.

For replacement, contact the technical service.