Gorenje BHP623E11B - Инструкция по эксплуатации - Страница 28

28               

This appliance is marked according to the European directive 2012/19/EC on Waste Electrical and Electronic Equipment 
(WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the 
environment and human health, which could otherwise be caused by inappropriate waste handling of this product.

The  symbol          

on the product, or on the documents accompanying the product, indicates that this appliance may 

not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electri

-

cal and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste 
disposal.
For further detailed information regarding the process, collection and recycling of this product, please contact the appropri

-

ate department of your local authorities or the local department for household waste or the shop where you purchased this 
product.

Appliance designed, tested and manufactured according to:

•

Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233. 

•

Performance:  EN/IEC  61591;  ISO  5167-1;  ISO  5167-3;  ISO  5168;  EN/IEC  60704-1;  EN/IEC  60704-2-13;  ISO  3741; 
EN 50564; IEC 62301. 

•

EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC 61000-3-3. 

Suggestions for a correct use in order to reduce the environmental impact: Switch ON the hood at minimum speed when you 
start cooking and kept it running for few minutes after cooking is finished. Increase the speed only in case of large amount 
of smoke and vapour and use boost speed(s) only in extreme situations. Replace the charcoal filter(s) when necessary to 
maintain a good odour reduction efficiency. Clean the grease filter(s) when necessary to maintain a good grease filter ef

-

ficiency. Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize noise. 

Additional Installation Specifications: 
Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type. Use 
the correct length for the screws which are identified in the Installation Guide. 
In case of doubt, consult an authorised service assistance centre or similar qualified person. 

WARNING!

 Failure to install the screws or fixing device in accordance with these instructions may result in electrical haz

-

ards. 

USE

The hood is designed to be used either for exhausting or filter version.

DUCTING VERSION

In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring 
located on top of the hood.

Attention!

 The exhausting pipe is not supplied and must be purchased apart. Diameter of the exhausting pipe must be equal 

to that of the connection ring.
In the horizontal runs the exhausting pipe must be slightly slanted (about 10°) and directed upwards to vent the air easily 
from the room to the outside.

Attention! 

If the hood is supplied with active charcoal filter, then it must be removed.

Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection flange).
Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance 
and a drastic increase in noise.
Any responsibility in the matter is therefore declined.

!

Use a duct of the minimum indispensible length.