Gorenje BHP 643 - Инструкция по эксплуатации - Страница 33

             EN 33

Buttons 

T7

 and 

T8

 are not visible at this stage (on some models). They are visible only as described 

in operation section of the manual.

Approximate distance of button 

T7

 from 

T6

 is 16 mm, and distance of but-

ton 

T8

 from 

T7

 is 26 mm.

Setting of Automatic Operation parameters

For correct use of the automatic operation, perform “Hood Calibration”.

Hood Calibration

With the display on (ON) and the suction off (OFF), press button 

T3

 for 5 seconds.

The suction speed (power) 1 starts functioning and button 

T3

 flashes to indicate that hood calibration is 

initiated and it will last for approx. 5 minutes.

Note: to interrupt the calibration, press 

T3

 for 5 seconds; the calibration will be invalidated and should 

therefore be repeated.

MAINTENANCE

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical 

supply by switching off at the connector and removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the plug must be removed 

from the socket.

CLEANING

The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out 

maintenance of the fat filters) internally and externally. Clean using the cloth dampened with neutral liquid 

detergent. Do not use abrasive products. 

DO NOT USE ALCOHOL!

WARNING:

 Failure to carry out the basic cleaning recommendations of the cooker hood and 

replacement of the filters may cause fire risks. Therefore, we recommend observing these instructions. 

The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to 

inappropriate maintenance or failure to observe the above safety recommendations.

GREASE FILTER

Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive 

detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. 

When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering 

capacity. To remove the grease filter, press it and pull it down.

CHARCOAL FILTER

 (filter version only)

It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more or 

less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. 

In any case it is necessary to replace the cartridge at least every four mounths. The charcoal filter may 

NOT be washed or regenerated.

REPLACING LAMPS

The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum 

lighting, a duration up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.

For replacement, contact the technical service.

T6

T7

T8

16 mm

26 mm