Gaggenau AI 541-122 - Инструкция по эксплуатации - Страница 15

13

Flexible aluminium pipes, corrosion-protected
sheet metal pipes and 

exhaust air 

pipes whose

material conforms to fire B1 in accordance with 
DIN 4102 can be used. Exhaust air pipes should
have a nominal diameter of 150 mm.

P

ay particular attention to ensuring

that

– the exhaust air ducts and pipes are kept as short

as possible

– the pipes are not laid at an acute angle, but as

bends and that they are inserted into the shaft at
an inclined upward angle and

– there are no cross-sectional constrictions in the

upward direction (this reduces the volume flow).

As 

standard

, the blow-out opening of the extractor

hood is in the upward direction.

To pass exhaust air through the outer wall, we
recommend the use of our telescopic wall box 
TM 150-045 (Ø 150).

Note:

T

o prevent the ingress of water, e.g. condensate or

rain water from an uncovered exhaust air shaft, our
condensate separator R V 060-150 must be installed
in the exhaust air line. The condensate separator
must still be acciessible after installation.

The duct units listed below are available
depending on the height of the ceiling:

IInstallation accessories for 

exhaust air mode

Stainless steel-design ventilation duct:

LK 010-016 

for ceiling heights of 

2.23 - 2.41 m

LK 010-026 

for ceiling heights of 

2.41 - 2.73 m

LK 010-036 

for ceiling heights of 

2.73 - 2.99 m

Aluminium-design ventilation duct:

LK 01

1-016 

for ceiling heights of 

2.23 - 2.41 m

LK 01

1-026 

for ceiling heights of 

2.41 - 2.73 m

LK 01

1-036 

for ceiling heights of 

2.73 - 2.99 m

Installation accessories for 

circulating air mode

Stainless steel-design ventilation duct:

LK 010-126

for ceiling heights of 

2.41 - 2.73 m

LK 010-136 

for ceiling heights of 

2.73 - 2.99 m

Aluminium-design ventilation duct:

LK 01

1-126

for ceiling heights of 

2.41 - 2.73 m

LK 01

1-136 

for ceiling heights of 

2.73 - 2.99 m

The dimensions above refer to a distance of 1.60 m
from the floor to the bottom edge of the hood.

If required, custom made duct units are available at
an extra charge.

The electrical socket must be placed within the
ventilation duct on the ceiling.

410,5

1200

700

261

630 - 1390

Fig. 18

2,23 - 2,99 m  

ceiling height

min. 600 over electric hob
min. 700 over gas hob