Falmec Virgola Plus 60 (600) ECP - Инструкция по эксплуатации - Страница 20

18

ONLY FOR ITALY: 

Download the specific order form of the filter from  www.falmec.com.

LIGHTING

I

1.  HALOGEN LAMP (Virgola smart)

To replace the “Square halogen light”:
a)   Make sure the appliance is disconnected from the electric power supply.
b)   Fully open the panel until reaching a 90° angle (see figure) pressing PUSH
c)   Replace the lamp with one similar (halogen max 20 W, 12 Volt G4 connection).
d)   Close the panel. If the panel does not close correctly, repeat the procedure from point b.

Square halogen light

2.   LED LAMP (Virgola Plus)

In this case the hood is equipped with high efficiency, low consumption LED lamp with 
extremely long duration under normal use conditions. The LED lamp must be replaced only 
by qualified technicians using only original spare parts.

MAINTENANCE

 AND CLEANING

L

Constant maintenance ensures the correct operation and efficiency of the appliance over 
time. Special attention should be paid to the metal grease-trapping filters and the charcoal 
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do 
not accumulate on the range hood, with the consequent risk of fire.

1.  METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore should be 
washed every month in hot water and detergent, without bending them. Wait until they 
are completely dry before repositioning them.  To remove and replace these filters, see 
the instructions in point H1. This operation should be performed at regular intervals.