Falmec Stilo 90 inox island (NRS) - Инструкция по эксплуатации - Страница 27

25

Pushbutton -

Press to reduce motor speed 

Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and 
the timer LEDs).

Pushbutton +

Press to increase motor speed 

Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and 
the timer LEDs). 

(In the 4-speed version the pushbutton + blinks. The fourth speed remains on for a set 
duration of time. After 7 minutes the motor returns to the third speed).

Mode pushbutton

Function: it turns hood motor on and off. 

 The 

function 

“desired speed”

 enables to start the motor at the speed that was selected 

before the hood was last turned off. 

 Optional: 

version with remote control (some versions only).

WARNING: 

Install the hood away from sources of electromagnetic waves, as these could affect the 
correct operation of the electronic system. 

Maximum operating distance: 5 metres. The maximum operating distance could be less 
than 5 metres in case of electromagnetic interference by other equipment. 

Light pushbutton on remote control:  light on/off. 

– and + pushbutton: increase/decrease speed (to start the motor press either the + or the 
– pushbutton). 

Timer pushbutton: see instructions below. 

Timer and ‘filter clogged’ alarm pushbutton 

• This function allows the automatic turning off of the hood after running for 15 minutes at 
the speed previously set (the pushbutton shows a flickering light). 

• After about 30 hours of running the pushbutton indicates the need for washing the metal 
filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton 
for a few seconds until the red light turns off. Then turn the hood off and on again to check 
that the alarm has disappeared.

2.   ELECTRONIC CONTROL PANEL (HORIZON NRS, LUMINA NRS, VELA NRS)

1: Timer/Alarm 

filters

The steady RED light 

indicates that the fat filter alarm is activated (after 30 hours), to de-

activate this alarm and zero the meters, maintain the Key pressed for 3 seconds.

Flashing RED light

 indicates that the timer function is activated. This function can only be 

activated if the motor is activated and running at any velocity when the Key is pressed 
(either prolonged or not). This function will cause the automatic switch-off of the hood 
after 7 minutes.

With the Timer function activated, the hood can be switched-off by the operator in any 
case and the function will be deactivated. 

The Timer function remains associated to a velocity. A change in the velocity, with the 
Timer function activated, will deactivate it.

English