Falmec Altair top 60 ix (800) ECP - Инструкция по эксплуатации - Страница 28

26

ASSEMBLY INSTRUCTIONS OF ALTAIR/MIRA ISLAND

Phase 1

- Due to packaging and transport requirements, the hood is provided with 

an extension and trellis assembled in the hood. Before proceeding with the 
installation: remove panel (AP), metal filters (F), loosen screws (V4) and re-
move the trellis (C-C1) with the extension (P). Separate the extension from 
the flange (SP), by loosening the screws (V3). See fig. 7.

- Detect the desired height (X is normally 65 cm, see sec. C) to place the hood 

(fig. 8).

- Scroll trellises (C) and (C1) until reaching the desired height (H2); subse-

quently, block them with 8 self-threaded screws (V2) (fig. 8).

- Fasten the trellis (C) and flange (SP) to the ceiling, using 8 Fischer Ø 8 and 

relative screws (V1) (Fig. 9).

-  In case of false ceiling, the flange (SP) can be fastened at the level of the false 

ceiling (fig. 10).

Phase 2

- In case of exhaust version: detect the optimal height of the elbow shaped or 

flexible tube of fume discharge (F) and connect it to the motor fitting (fig. 11).

- Insert the extension on the hood and lift the assembly, hooking it to the 4 M5 

metric screws (V4), which are pre-screwed to the trellis (C) (centre the Ø11 
holes to the slot of the interchamber and move it sideways) (fig. 11). Fasten 
the 4 M5 screws permanently (V4).

- Connect the tube (F) to the discharge hole of the ceiling (in case of exhaust 

version). See fig. 12.

- Carry out electric connection only after having disconnected the electric po-

wer supply.

- Lift the extension and fasten it to the flange (SP) 4 M4 metric screws (V3). 

See fig. 13.

Phase 3

- Re-assemble the metal filters and panel (AP) and power the hood complying 

with the regulations in force.