Faber SWIFT X/WH GLASS A60 - Инструкция по эксплуатации - Страница 3

3

Recommendations  
and suggestions

• The Instructions for Use apply 

to several versions of this appli-

DQFH $FFRUGLQJO\ \RX PD\ ¿QG

descriptions of individual features 

WKDW GR QRW DSSO\ WR \RXU VSHFL¿F

appliance.

•  The manufacturer will not be held 

liable for any damages resulting 
from incorrect or improper instal-
lation.

• The minimum safety distance 

between the cooker top and the 
extractor hood is 650 mm (some 
models can be installed at a 
lower height, please refer to the 
paragraphs on working dimensions 
and installation).

• Check that the mains voltage 

corresponds to that indicated on 

WKHUDWLQJSODWH¿[HGWRWKHLQVLGH

of the hood.

•  For Class I appliances, check that 

the domestic power supply guaran-
tees adequate earthing. Connect 

WKH H[WUDFWRU WR WKH H[KDXVW ÀXH

through a pipe of minimum diam-
eter 120 mm. The route of the 

ÀXHPXVWEHDVVKRUWDVSRVVLEOH

•  Do not connect the extractor hood 

to exhaust ducts carrying combus-

WLRQIXPHVERLOHUV¿UHSODFHVHWF

•  If the extractor is used in conjunc-

tion with non-electrical appliances 
(e.g. gas burning appliances), 

D VXI¿FLHQW GHJUHH RI DHUDWLRQ

must be guaranteed in the room 

LQ RUGHU WR SUHYHQW WKH EDFNÀRZ

of exhaust gas. The kitchen must 
have an opening communicating 
directly with the open air in order 

to guarantee the entry of clean air. 
When the cooker hood is used 
in conjunction with appliances 
supplied with energy other than 
electric, the negative pressure in 
the room must not exceed 0,04 
mbar to prevent fumes being 
drawn back into the room by the 
cooker hood.

• In the event of damage to the 

power cable, it must be replaced 
by the manufacturer or by the 
technical service department, in 
order to prevent any risks.

• If the instructions for installation 

for the gas hob specify a greater 

GLVWDQFHVSHFL¿HGDERYHWKLVKDV

to be taken into account. Regula-
tions concerning the discharge of 

DLU KDYH WR EH IXO¿OOHG

• Use only screws and small parts 

in support of the hood.

Warning:

 Failure to install the 

VFUHZVRU¿[LQJGHYLFHLQDFFRUG

-

ance with these instructions may 
result in electrical hazards.

• Connect the hood to the mains 

through a two-pole switch having 
a contact gap of at least 3 mm.

Use

• The extractor hood has been 

designed exclusively for domestic 
use to eliminate kitchen smells.

• Never use the hood for purposes 

other than for which it has been 
designed.

• 

1HYHU OHDYH KLJK QDNHG ÀDPHV

under the hood when it is in op-
eration.

• 

$GMXVWWKHÀDPHLQWHQVLW\WRGLUHFW

it onto the bottom of the pan only, 

EN