Faber LYBRA ZEBRA-STRIPED (SET) - Инструкция по эксплуатации - Страница 4

EN 

4

4 

RECOMMENDATIONS AND SUGGESTIONS

The Instructions for Use apply to several versions of this appliance. 
Accordingly, you may find descriptions of individual features that do not 
apply to your specific appliance. 

INSTALLATION 

• 

The manufacturer will not be held liable for any damages resulting from 
incorrect or improper installation. 

•  The minimum safety distance between the cooker top 

and the extractor hood is 650 mm (some models can 
be installed at a lower height, please refer to the 
paragraphs on working dimensions and installation). 

•  Check that the mains voltage corresponds to that 

indicated on the rating plate fixed to the inside of the 
hood. 

•  For Class I appliances, check that the domestic 

power supply guarantees adequate earthing. 

  Connect the extractor to the exhaust flue through a pipe of minimum 

diameter 120 mm. The route of the flue must be as short as possible.

•  Do not connect the extractor hood to exhaust ducts carrying combustion 

fumes (boilers, fireplaces, etc.). 

•  If the extractor is used in conjunction with non-

electrical appliances (e.g. gas burning 
appliances), a sufficient degree of aeration must 
be guaranteed in the room in order to prevent the 
backflow of exhaust gas. The kitchen must have 
an opening communicating directly with the open 
air in order to guarantee the entry of clean air.

When the cooker hood is used in conjunction with 
appliances supplied with energy other than electric, the negative pressure in 
the room must not exceed 0,04 mbar to prevent fumes being drawn back 
into the room by the cooker hood.

•  In the event of damage to the power cable, it must be replaced by the 

manufacturer or by the technical service department, in order to prevent any 
risks.  

2°