Вытяжки Faber ILMA X A120 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
EN
USE
26
Control panel
Turns the motor on/off at speed one
,
the rel
evant
button LED turns on, and stays
on at all speeds.
Press briefly to start the motor, if pressed by any speed the motor turns off.
•
Turns the Motor on at speed two
,
the rel
evant
button LED turns on only at 2° speed.
•
Press and hold the button for approximately 2 seconds, with all the loads turned
off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The LED
flashes twice to confirm. To turn the alarm off, press the button again and hold for
at least 2 seconds. The LED flashes once.
Turns the lights ON/OFF and also the rel
evant
LED.
Turns the STEAM_SYSTEM on/off (ONLY WITH MOTOR ON); when the SoS is on, the
relevant LED turns on. WHEN THE USERS TURN THE MOTOR OFF, THE SYSTEM GOES OFF.
•
With all the loads turned off (Motor and Light)
,
pressing and holding the button
for approximately 2 seconds, the remote control is disabled, indicated by the LED
flashing just once. Pressing again, the remote control is enabled
, indicated by the
LED flashing twice.
Turns the Motor on at speed three, the relevant button LED turns on only at 3° speed.
•
Press and hold the button for approximately 2 seconds
to turns the Motor on at
INTENSIVE Speed, the LED flashes every 0.5”. This speed is timed to run for 6
minutes. At the end of this time, the system returns automatically to the
speed that was set before. If it is activated with the motor turned off, it will switch
to OFF at the end of the time. It is deactivated by pressing the same button, or any
speed button or the button to turn off the motor.
•
The Metal Grease Filter saturation
occurs
after the Hood has been in
operation for 100 working hours
,
indicated by the LED flashing
every 1"
•
The Activated Charcoal Filter saturation
occurs
after the Hood has been
in operation for 200 working hours
,
ndicated by the LED flashing
every 0.5"
FILTERS ALARM
W
ith all the loads turned off (Motor and Light), if
the filters alarm is activ
e
, reset
the alarm
by pressing this button for approximately 2 seconds: all Leds will flash 3
times.
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
