Faber 741 BASE W A60 - Инструкция по эксплуатации - Страница 2

2

EN - SAFETY INFORMATION - 

For your safety and correct operation 

of the appliance, read this manual carefully before installation and use. 

Always keep these instructions with the appliance even if you move or 

sell it. Users must fully know the operation and safety features of the 

appliance. The wire connection has to be done by specialized techni-

cian. The manufacturer will not be held liable for any damages resulting 

from incorrect or improper installation. The minimum safety distance 

between the cooker top and the extractor hood is 650 mm (some mod-

els can be installed at a lower height, please refer to the paragraphs 

on working dimensions and installation). If the instructions for installa-

tion for the gas hob specify a greater distance, this must be respected. 

Check that the mains voltage corresponds to that indicated on the rating 

plate fixed to the inside of the hood. Means for disconnection must be 

incorporated in the fixed wiring in accordance with the wiring rules. For 

Class I appliances, check that the domestic power supply guarantees 

adequate earthing. Connect the extractor to the exhaust flue through a 

pipe of minimum diameter 120 mm. The route of the flue must be as 

short as possible. Regulations concerning the discharge of air have to 

be fulfilled. Do not connect the extractor hood to exhaust ducts carrying 

combustion fumes (boilers, fireplaces, etc.). If the extractor is used in 

conjunction with non-electrical appliances (e.g. gas burning applianc-

es), a sufficient degree of aeration must be guaranteed in the room in 

order to prevent the backflow of exhaust gas. When the cooker hood 

is used in conjunction with appliances supplied with energy other than 

electric, the negative pressure in the room must not exceed 0,04 mbar 

to prevent fumes being drawn back into the room by the cooker hood. 

The air must not be discharged into a flue that is used for exhausting 

fumes from appliances burning gas or other fuels. If the supply cord 

is damaged, it must be replaced from the manufacturer or its service 

agent. Connect the plug to a socket complying with current regulations, 

located in an accessible place. With regards to the technical and safety 

measures to be adopted for fume discharging it is important to closely 

follow the regulations provided by the local authorities. 

WARNING:

 Be-

fore installing the Hood, remove the protective films. Use only screws 

and small parts in support of the hood. 

WARNING:

 Failure to install the 

screws or fixing device in accordance with these instructions may re

-

sult in electrical hazards. Do not look directly at the light through optical 

devices (binoculars, magnifying glasses…). Do not flambè under the 

range hood; risk of fire. This appliance can be used by children aged 

from 8 years and above and persons with reduced physical, sensory