ELICA PIX BL/F/42 - Инструкция по эксплуатации - Страница 25

25 

or 

2 

(carbon filter) stops flashing. 

EXCLUDING THE ELECTRONICS

Press the key for 3 seconds. The hood 
command electronics will be excluded. 
This function can be useful during the product 
cleaning operations. 
Just repeat the operation to reinsert the 
electronics.  

 
If the hood fails to operate correctly, briefly disconnect it from 
the mains power supply for almost 5 sec. by pulling out the 
plug. Then plug it in again and try once more before 
contacting the Technical Assistance Service. 

Maintenance 
 

Clean using 

ONLY

 a cloth dampened with neutral liquid 

detergent. 

DO NOT CLEAN WITH TOOLS OR 

INSTRUMENTS

. Do not use abrasive products. 

DO NOT USE 

ALCOHOL! 

Grease filter 
Fig. 19-23 
The grease filter

 must be cleaned once a month using non 

aggressive detergents, either by hand or in the dishwasher, 
which must be set to a low temperature and a short cycle.  
When washed in a dishwasher, the grease filter may discolor 
slightly, but this does not affect its filtering capacity. 

Charcoal filter (filter version only) 
Fig. 22 

The charcoal filter can be washed once every two months (or 
when the filter saturation indication system – if envisaged on 
the model in possession – indicates this necessity)   using hot 
water and a suitable detergent, or in a dishwasher at 65°C (if 
the dishwasher is used, select the full cycle function and leave 
dishes out). 
Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 

Replacing lamps 

The hood is equipped with a lighting system based on LED 
technology. 
The LEDs guarantee an optimum lighting, a duration up to 10 
times as long as the traditional lamps and allow to save 90% 
electrical energy. 
 
To replace lights, contact authorised spare part center.