Вытяжки ELICA PANDORA GME IX/A/90 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
10
In order to keep the grease filter efficient
over time, clean it whenever necessary.
Use a piping system with the maximum
diameter specified in this manual, in or-
der to reach very high performances and
maintain low noise levels.
Use
The hood can be used both in aspiration
mode with external discharge of suctio-
ned air, and in filtering mode, where the
air is recycled back into the room.
Aspiration Mode
Vapours are discharged to the outside,
through the specific exhaust pipe fixed
to the flange.
The exhaust pipe diameter shall be the
same as the connection ring diameter.
Caution! The exhaust pipe is not sup-
plied with the appliance and shall be
purchased. The pipe shall have a light
upwards inclination (about 10° ) in its
horizontal part, in order to convey the
air to the outside more easily. If the
hood is equipped with charcoal filters,
they shall be removed.
Filtering mode
The air that is sucked in will be ‘degre-
ased’ before being re-conveyed into the
room. If you wish to use the hood in this
mode, you will need to buy an additional
filtering system with activated charcoal
filers.
Note: The air recycled through the char-
coal filters is conveyed back into the
kitchen through a duct that conveys the
air along a side of the cabinet.
Installation
Note: installation shall be performed in
such a way as to allow that the hood and
its electric components can be easily ac-
cessible in case of technical assistance.
WARNING
Place the metal box contai-
ning the electronic components at a mi-
nimum distance of 65 cm from the gas
hob or anyway at 65 cm from the hood
aspiration area.
RECOMMENDATION:
we advise that
you install the metal box, containing the
electronic components, at 10 cm from
the floor, at least, and at a safe distan-
ce from any heat source (e.g.: an oven
side, or a hob).
In the case that the installation instruc-
tions of your gas cooker mention a hi-
gher distance, please comply with this
requiremen..
Electrical Connection
The connection of the hood to the power
supply shall be performed by qualified
and specialised technical personnel.
The mains voltage shall correspond to
the voltage value specified on the ra-
ting label found inside the hood. If the
appliance is equipped with a plug, the
hood shall be connected to a socket
which is compliant with the relevant
standards in force, and which is loca-
ted in an easily reachable area, also
after installation. If the appliance is not
equipped with a plug (direct connection
to power supply), or if the plug is not
found in an easily reachable place after
installation, use an approved double-
pole main switch, ensuring complete
disconnection from the power supply at
the overvoltage category III conditions,
in accordance with the installation pro-
cedure.
Caution!
Before reconnecting the hood
electric circuit to the power supply, and
to check for proper operation, please
always make sure the mains lead has
been installed properly.
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
