Elica OM AIR POP/F/75 - Инструкция по эксплуатации - Страница 20

20 

Operation 

Use the high suction speed in cases of concentrated kitchen 
vapours.  It is recommended that the cooker hood suction is 
switched on for 5 minutes prior to cooking and to leave in 
operation during cooking and for another 15 minutes 
approximately after terminating cooking.  
  
To select the functions of the hood just touch the commands. 
 

Light key ON/OFF 

Intensive speed selection key

(suction 

power) - duration 5 minutes - press again to 
return to previous setting. 

High-speed selection key 

(suction power). 

Medium-speed selection key

 (suction power)

- when flashing it indicates the need to wash or 
replace the carbon filter. This signal is normally 
deactivated. To activate the alarm, disable the 
electronic by pressing the 

0

button for 3 

seconds.  
Next, simultaneously press buttons 

1

 and 

2

for 

3 seconds; at first, only button 

1

will flash, then 

both buttons 

1

 and 

2

 will flash to indicate 

activation. Repeat the procedure to deactivate 
the alarm; at first buttons 

1

 and 

2

will flash and 

subsequently only button 

1

to indicate 

deactivation. 

Low-speed selection key

 (suction power) –

when flashing it indicates the need to wash the 
fats filter. 

Motor key OFF

 (stand by) – excludes the 

electronics – reset wash/replace filters signals. 

MOTOR OFF 

Press briefly to switch the motor off. 

RESET FILTERS SIGNALS

In functioning mode, after carrying out filter 
maintenance, press the key until hearing the 
sound signal. The flashing LED 

1 

(grease filter) 

or 

2 

(carbon filter) stops flashing. 

EXCLUDING THE ELECTRONICS

Press the key for 3 seconds. The hood 
command electronics will be excluded. 
This function can be useful during the product 
cleaning operations. 
Just repeat the operation to reinsert the 
electronics.  

 
If the hood fails to operate correctly, briefly disconnect it from 
the mains power supply for almost 5 sec. by pulling out the 

plug. Then plug it in again and try once more before 
contacting the Technical Assistance Service. 
  

Note

: with  the hood ON, the outer ring of the hood retreats 

("open" position) to allow the passage of air. 
Turning off the hood 'the ring returns to rest position ("closed" 
position).

Note:

 The perimeter suction panel should always be left 

closed and should only be opened when maintenance is 
performed.  
A special device prevents accidental movement of the outer 
ring with the perimeter suction panel open. 

Cleaning mode: 

Exclude electronic components (see "

EXCLUDING THE 

ELECTRONICS

" 

in the previous paragraph.. 

Press 

 and 

 for 3 seconds, buttons start flashing to 

indicate that you are in "

Cleaning mode

" and it is therefore 

possible to perform filters’ maintenance or access the motor 
compartment.  

Press the button 

 for 3 seconds to exit the "

Cleaning 

mode

" function.