Elica ICO BL/F/80 - Инструкция по эксплуатации - Страница 15

15 

T3. “Boost” mode 

This mode is not associated with any specific type of cooking. 
Press the button in the case of particularly intense fumes. 
Press button T1 or T3 and the hood passes to OFF. 
 

T4. Lighting ON/OFF  

Press the button to turn the lights on or off. 
The lighting turns on gradually without intermediate level 
adjustments. 
 

T5. Cooking mode. 

Press the button cyclically to activate the different suction 
modes. 
Each mode is associated with different types of food cooking. 
This is to obtain optimum suction according to the different 
needs. 
A signalling LED corresponds to each suction mode. 

•

“Slow cooking” mode LED L1 on 

Press the button when cooking vegetables in a pan, 
when heating food or drinks (milk, coffee, tea). 

•

“Boiling” mode LED L2 on 

Press the button when cooking sauces, broth, boiled 
vegetables and soups, or when boiling food (e.g. pasta). 

•

“Grilling” mode LED L3 on 

Press the button when cooking food on grill or griddle. 

•

“Frying” mode LED L4 on 

Press the button when frying food (e.g. meat, potatoes, 
vegetables). 

 
To quit the selected suction mode press the following buttons: 
Button T1 hood in OFF 
Button T2 activation of “Silent” mode 
Button T3 activation of “Boost” mode 

 
Fault alarm 

In case of motor fault (stall, overheating, etc.) all the functions 
of the motor will be blocked (except for lighting) buttons T2, 
T3, T5 and LEDs L1, L2, L3, L4 will flash. 
Once the alarm has gone off, the hood goes back to OFF. 
Press button T1 and the hood passes to OFF. 
If the fault persists, the hood remains in the alarm state and all 
the functions are blocked. Contact the technical service. 

Maintenance 

ATTENTION! 

Before performing any maintenance operation, 

isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 

same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. 

DO NOT USE ALCOHOL!

WARNING: 

Failure to carry out the basic cleaning 

recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend observing these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Steam screen 

The steam screen must always be left closed and 
opened only for maintenance (e.g. cleaning or changing 
filters).   

Grease filter 

Fig. 13-27 
Traps cooking grease particles. 

This must be cleaned once a month (or when the filter 
saturation indication system – if envisaged on the model in 
possession – indicates this necessity)  using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle. 
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
Open the steam screen.  
To remove the grease filter, pull the spring release handle. 

Charcoal filter (filter version only) 

Fig. 26 
It absorbs unpleasant odours caused by cooking. 

The charcoal filter can be washed once every two months 
using hot water and a suitable detergent, or in a dishwasher at 
65°C (if the dishwasher is used, select the full cycle function 
and leave dishes out). 
Eliminate excess water without damaging the filter, then put it 
in the oven for 10 minutes at 100° C to dry completely. 
Replace the mattress every 3 years and when the cloth is 
damaged. 
• 

Montage 

Open the steam screen and remove the grease filter.  

Install the carbon filter on the back of the grease filter and 
fix with two rods.    

Attention!

 The rods are included in the carbon filter 

packing and not on the hood.   

• 

To dismantle the filter act in the reverse manner. 

Replacing lamps 

  
The hood is equipped with a lighting system based on LED 
technology. 
The LEDs guarantee an optimum lighting, a duration up to 10 
times as long as the traditional lamps and allow to save 90% 
electrical energy. 
 
For replacement, contact the technical service.